Difficulty

Moderate

Steps

5

Time Required

                          4 - 5 minutes

Sections

1

  • Hard Drive
  • 5 steps

Flags

4

In Progress

This guide is a work in progress. Reload periodically to see the latest changes!

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackDell Latitude E6500

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Step 1

              removing hard drive
  • Do not remove the hard drive while the computer is on or in sleep state. This might cause data loss.
  • Place the computer upside down on a clean, flat surface. Remove the bottom of the base assembly
  • Remove the bottom of the base assembly

Do not remove the hard drive while the computer is on or in sleep state. This might cause data loss.

Place the computer upside down on a clean, flat surface. Remove the bottom of the base assembly

Remove the bottom of the base assembly

1024

Step 2

              remove screws
  • Remove the four M3 x 3-mm screws (marked with an “H”) that secure the hard drive

Remove the four M3 x 3-mm screws (marked with an “H”) that secure the hard drive

Step 3

              Slide the hard drive out of the computer.
  • Slide the hard drive out of the computer.

Slide the hard drive out of the computer.

Step 4

              remove the M3 x 3mm screw from the bezel
  • Remove the M3 x 3mm screw from the bezel and take the bezel off the hard drive.

Remove the M3 x 3mm screw from the bezel and take the bezel off the hard drive.

Step 5

              Replacing the hard drive
  • Attach the bezel to the hard drive using the M3 x 3mm screw.
  • Slide the hard drive into the bay until it is fully seated

Attach the bezel to the hard drive using the M3 x 3mm screw.

Slide the hard drive into the bay until it is fully seated

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Marvin Romero

Member since: 03/18/2021

3,709 Reputation

                                      32 Guides authored                  



                       Badges:
                       2

Team

                       Informative Technologies Inc.                        

                                                  Member of Informative Technologies Inc. 



                    Community                     


                                            38 Members                     


                                            1,980 Guides authored