Difficulty

Moderate

Steps

8

Time Required

                          5 minutes

Sections

2

  • Battery
  • 2 steps
  • Display
  • 6 steps

Flags

0

  • BackDell Latitude E4310

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Power down the laptop and remove all power cords.

Power down the laptop and remove all power cords.

1024

Step 2

  • Push in the battery release button with your thumb.
  • Pull up on the battery to remove.

Push in the battery release button with your thumb.

Pull up on the battery to remove.

Step 3

              Display
  • Open up the laptop and flatten it down on a workable surface.
  • Turn it around so that the screen is closest to you.
  • Insert the flat end of a spudger, or plastic opening tool, into the groove between the screen bezel and top case.
  • Twist the spudger, or plastic opening tool, until you hear a clicking sound and continue doing this around the entirety of the display.
  • Remove the bezel.

Open up the laptop and flatten it down on a workable surface.

Turn it around so that the screen is closest to you.

Insert the flat end of a spudger, or plastic opening tool, into the groove between the screen bezel and top case.

Twist the spudger, or plastic opening tool, until you hear a clicking sound and continue doing this around the entirety of the display.

Remove the bezel.

Step 4

  • Remove the six 0.3mm Phillips #1 screws.

Remove the six 0.3mm Phillips #1 screws.

Step 5

  • Remove the two 0.5mm Phillips #1 screws.
  • There are two screws located at each corner. Only remove the ones closest to the outer edge.

Remove the two 0.5mm Phillips #1 screws.

There are two screws located at each corner. Only remove the ones closest to the outer edge.

Step 6

  • Carefully lift the screen up and flip it over onto the keyboard side as if you were turning the page of a book.

Carefully lift the screen up and flip it over onto the keyboard side as if you were turning the page of a book.

Step 7

  • Use a pair of tweezers to flip the blue tape 180 degrees.
  • By flipping the tape you disconnect the display connector.

Use a pair of tweezers to flip the blue tape 180 degrees.

By flipping the tape you disconnect the display connector.

Step 8

  • Remove the screen from the laptop.

Remove the screen from the laptop.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.

Author

                                      with 2 other contributors 


                    Aylin

Member since: 02/21/2018

261 Reputation

                                      1 Guide authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       University of North Texas, Team S1-G5, Thompson Spring 2018                        

                                                  Member of University of North Texas, Team S1-G5, Thompson Spring 2018 



                    UNT-THOMPSON-S18S1G5                     


                                            4 Members                     


                                            8 Guides authored