Difficulty

Easy

Steps

6

Time Required

                          5 - 7 minutes

Sections

2

  • Keyboard
  • 3 steps
  • Keyboard Docking Component
  • 3 steps

Flags

0

  • BackDell Latitude E4300

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Keyboard
  • Open the laptop and remove the small panel located above the keyboard.

Open the laptop and remove the small panel located above the keyboard.

1024

Step 2

  • Using a Phillips 1 Screwdriver, unscrew the three M2x3-mm screws located above the keyboard where the small panel was originally.

Using a Phillips 1 Screwdriver, unscrew the three M2x3-mm screws located above the keyboard where the small panel was originally.

Step 3

  • Pull off keyboard forward and then outwards.
  • The keyboard is fragile, so make sure you pull the keyboard off carefully.

Pull off keyboard forward and then outwards.

The keyboard is fragile, so make sure you pull the keyboard off carefully.

Step 4

              Keyboard Docking Component
  • With your Phillips 1 screwdriver, unscrew the five M2.5x5-mm screws and the five M2.5x8-mm screws that lie underneath the keyboard panel.
  • Be aware there are two deeply recessed screws on both sides to the rear of this panel. There are also two screws externally on the rear face either side of the battery that hold the monitor on and pass through this panel, support the screen when you remove these. There are also two screws above the hard drive bay that need to be removed.

With your Phillips 1 screwdriver, unscrew the five M2.5x5-mm screws and the five M2.5x8-mm screws that lie underneath the keyboard panel.

Be aware there are two deeply recessed screws on both sides to the rear of this panel. There are also two screws externally on the rear face either side of the battery that hold the monitor on and pass through this panel, support the screen when you remove these. There are also two screws above the hard drive bay that need to be removed.

Step 5

  • Remove additional wires located within the panel.
  • For the smaller wires, try using a spudger for easier access.

Remove additional wires located within the panel.

For the smaller wires, try using a spudger for easier access.

Step 6

  • Lift the keyboard panel to separate the component from the rest of the device.

Lift the keyboard panel to separate the component from the rest of the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Ryan Blakey

Member since: 09/24/2018

172 Reputation

                                      2 Guides authored                  



                       Badges:
                       2

Team

                       University of North Texas, Team S6-G5, Thompson Fall 2018                        

                                                  Member of University of North Texas, Team S6-G5, Thompson Fall 2018 



                    UNT-THOMPSON-F18S6G5                     


                                            4 Members                     


                                            5 Guides authored