Difficulty
Moderate
Steps
17
Time Required
15 - 25 minutes
Sections
2
- Keyboard
- 7 steps
- Display
- 10 steps
Flags
0
BackDell Latitude D620
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Keyboard
- Power down the laptop and remove the battery.
- Open the laptop cover all of the way.
Power down the laptop and remove the battery.
Open the laptop cover all of the way.
1024
Step 2
- Locate the notch under the cover at the top of the keyboard
- Using the spudger as a lever, lift the plastic covering
- Carefully remove the rest of the covering from right to left
Locate the notch under the cover at the top of the keyboard
Using the spudger as a lever, lift the plastic covering
Carefully remove the rest of the covering from right to left
Step 3
- Unscrew the top portion of the keyboard using a #00 screwdriver
Unscrew the top portion of the keyboard using a #00 screwdriver
Step 4
- Hold keyboard from the top and gently pull towards the LCD screen to remove the keyboard from the case
- Don’t pull on the keyboard too forcefully because it is attached to the motherboard with a short, thin ribbon cable
Hold keyboard from the top and gently pull towards the LCD screen to remove the keyboard from the case
Don’t pull on the keyboard too forcefully because it is attached to the motherboard with a short, thin ribbon cable
Step 5
- Once keyboard is out of the case, lay it face-down on the track pad
Once keyboard is out of the case, lay it face-down on the track pad
Step 6
- Using a small spudger, pull back on the black bar to release the blue lever
Using a small spudger, pull back on the black bar to release the blue lever
Step 7
- Pull up on the metal bar connected to the socket to detach the ribbon cable
Pull up on the metal bar connected to the socket to detach the ribbon cable
Step 8
Display
- Detach cables that connect the display to the body of the laptop
Detach cables that connect the display to the body of the laptop
Step 9
- Disconnect the black cable attached to the motherboard
Disconnect the black cable attached to the motherboard
Step 10
- Close the laptop lid
- Turn the laptop over onto its backside
- Unscrew the two screws shown in the picture using a #00 screwdriver
Close the laptop lid
Turn the laptop over onto its backside
Unscrew the two screws shown in the picture using a #00 screwdriver
Step 11
- Face the laptop’s back ports towards you
- Unscrew the two screws labeled in the picture using a #00 screwdriver
Face the laptop’s back ports towards you
Unscrew the two screws labeled in the picture using a #00 screwdriver
Step 12
- Turn the laptop over again so it’s right-side up
- Open the display, and pull the display up and out of the laptop’s body
Turn the laptop over again so it’s right-side up
Open the display, and pull the display up and out of the laptop’s body
Step 13
- Remove the circular rubber pads as outlined in the picture using a spudger
Remove the circular rubber pads as outlined in the picture using a spudger
Step 14
- Unscrew the screws that were under the rubber circles using the #00 screwdriver
Unscrew the screws that were under the rubber circles using the #00 screwdriver
Step 15
- Carefully use a spudger to work around the edge of the screen to lift off the plastic cover
- Be very careful while doing this as the plastic snaps easily
Carefully use a spudger to work around the edge of the screen to lift off the plastic cover
Be very careful while doing this as the plastic snaps easily
Step 16
- Remove the screws outlined in the picture
Remove the screws outlined in the picture
Step 17
- Carefully lift the LCD screen out of its casing
Carefully lift the LCD screen out of its casing
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
19 other people completed this guide.
Author
with 9 other contributors
Miguel Wong
Member since: 04/15/2010
541 Reputation
3 Guides authored
Badges:
11
+8 more badges
Team
Cal Poly, Team 24-35, Regan Spring 2010
Member of Cal Poly, Team 24-35, Regan Spring 2010
CPSU-REGAN-S10S24G35
4 Members
4 Guides authored
bob harris - Mar 2, 2013
Reply
Check out this replacement screen at a great price on bcdelectrostore.com
