Difficulty

Moderate

Steps

8

Time Required

                          10 minutes

Sections

1

  • Screen
  • 8 steps

Flags

0

  • BackDell Latitude D530

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Screen
  • Remove the 4 small circle dots from the borders of the laptop screen. Simply pull the dots out of their sockets.
  • Also remove the one longer rubber piece from the top of the screen. Simply peel the rubber piece from its place.

Remove the 4 small circle dots from the borders of the laptop screen. Simply pull the dots out of their sockets.

Also remove the one longer rubber piece from the top of the screen. Simply peel the rubber piece from its place.

1024

Step 2

  • Unscrew and remove the 6 6mm screws that were under the rubber pieces using a Phillips #1.
  • If the screws will not come out easily, use the magnetic bit to remove the screws all illustrated.

Unscrew and remove the 6 6mm screws that were under the rubber pieces using a Phillips #1.

If the screws will not come out easily, use the magnetic bit to remove the screws all illustrated.

Step 3

  • Use the spudger to pry the plastic border off.
  • Be sure that the plastic notch at the bottom of the screen is pulled out correctly. Pull the border to the left of the screen and out.

Use the spudger to pry the plastic border off.

Be sure that the plastic notch at the bottom of the screen is pulled out correctly. Pull the border to the left of the screen and out.

Step 4

  • Unscrew the 8 6mm screws located on the outer border of the screen using a Phillips #1.
  • There are 4 screws on each side.

Unscrew the 8 6mm screws located on the outer border of the screen using a Phillips #1.

There are 4 screws on each side.

Step 5

  • Use the spudger to pry the screen up.

Use the spudger to pry the screen up.

Step 6

  • Lift the screen up and fold over gently.

Lift the screen up and fold over gently.

Step 7

  • Pull on the blue tag sticking out at the bottom of the screen and disconnect the wire.

Pull on the blue tag sticking out at the bottom of the screen and disconnect the wire.

Step 8

  • Towards the top of the screen on the back, unplug the “this side up” wire.
  • This can be done by squeezing the 2 metal side clips of the wire.
  • This could be difficult so wiggling the wire a little bit may be necessary.

Towards the top of the screen on the back, unplug the “this side up” wire.

This can be done by squeezing the 2 metal side clips of the wire.

This could be difficult so wiggling the wire a little bit may be necessary.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Kyle Cabral

Member since: 03/19/2018

604 Reputation

                                      4 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       UMass Dartmouth, Team S2-G6, Bernier Spring 2018                        

                                                  Member of UMass Dartmouth, Team S2-G6, Bernier Spring 2018 



                    UMASSD-BERNIER-S18S2G6                     


                                            3 Members                     


                                            4 Guides authored