Difficulty

Easy

Steps

6

Time Required

                          5 minutes

Sections

3

  • Base Panel
  • 2 steps
  • Speakers
  • 2 steps
  • Fan
  • 2 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackDell Latitude 9510

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Base Panel
  • Flip the device so that the base plate is facing you.
  • Use a Phillips #0 screwdriver to remove the nine 5.5 mm screws securing the base plate.

Flip the device so that the base plate is facing you.

Use a Phillips #0 screwdriver to remove the nine 5.5 mm screws securing the base plate.

1024

Step 2

  • Wedge a spudger between the base plate and the chassis, then gently pry around the entire perimeter to release the base plate.
  • Remove the base plate.

Wedge a spudger between the base plate and the chassis, then gently pry around the entire perimeter to release the base plate.

Remove the base plate.

Step 3

              Speakers
  • Use a Phillips #0 screwdriver to remove the four 2 mm screws from the speakers.

Use a Phillips #0 screwdriver to remove the four 2 mm screws from the speakers.

Step 4

  • Use a spudger to gently lever the speaker connector out of its port.
  • Lift the speakers up and out.

Use a spudger to gently lever the speaker connector out of its port.

Lift the speakers up and out.

Step 5

              Fan
  • Use a Phillips #0 screwdriver to remove the two 3 mm screws securing the fan.

Use a Phillips #0 screwdriver to remove the two 3 mm screws securing the fan.

Step 6

  • Place your fingernails behind the plastic tabs on the speaker’s motherboard connector, then pull directly backwards, toward the wires, until the connector releases from its port.
  • Lift the fan up and out.

Place your fingernails behind the plastic tabs on the speaker’s motherboard connector, then pull directly backwards, toward the wires, until the connector releases from its port.

Lift the fan up and out.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Adam Sholar

Member since: 02/08/2022

243 Reputation

                                      2 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       Western Carolina University, Team 1-5, Virtue Spring 2022                        

                                                  Member of Western Carolina University, Team 1-5, Virtue Spring 2022 



                    WCU-VIRTUE-S22S1G5                     


                                            4 Members                     


                                            4 Guides authored