Difficulty

Easy

Steps

5

Time Required

                          15 minutes

Sections

1

  • RAM
  • 5 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackDell Latitude 3450

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Video Overview

Step 1

              Getting Started
  • Ensure the laptop is powered off .
  • Flip the laptop over.

Ensure the laptop is powered off .

Flip the laptop over.

1024

Step 2

              Removing the Rear Cover
  • Loosen the two Phillips head screws.
  • These screws should back out, but should not actually be removable.
  • Locate the indent on the rear cover half way between the two Phillips head screws.
  • Insert your spudger to help pry up the rear cover.
  • It may be necessary to run the spudger along the side with the indent to help release the clips
  • Lift off the rear cover.

Loosen the two Phillips head screws.

These screws should back out, but should not actually be removable.

Locate the indent on the rear cover half way between the two Phillips head screws.

Insert your spudger to help pry up the rear cover.

It may be necessary to run the spudger along the side with the indent to help release the clips

Lift off the rear cover.

Step 3

              Installing the RAM
  • The RAM slots are in line with the hard drive, and on the right side if the cover was opened away from you.
  • Please note that there are A and B RAM Slots. There must be a RAM chip in the A Slot, or the laptop will not load normally.
  • The Slots are labeled on the board, under where the chips would normally be seated.

The RAM slots are in line with the hard drive, and on the right side if the cover was opened away from you.

Please note that there are A and B RAM Slots. There must be a RAM chip in the A Slot, or the laptop will not load normally.

The Slots are labeled on the board, under where the chips would normally be seated.

Step 4

              Installing the RAM
  • Ensure that the space in the RAM chip lines up with alignment pin on the slot.
  • Insert the RAM chip at approximately at 45° angle.
  • Once the chip bottoms out on the slot, push down on the opposite side from the pins until the RAM chip seats on the board.

Ensure that the space in the RAM chip lines up with alignment pin on the slot.

Insert the RAM chip at approximately at 45° angle.

Once the chip bottoms out on the slot, push down on the opposite side from the pins until the RAM chip seats on the board.

Step 5

              OPTIONAL: Removal of RAM
  • Depending on your machines current configuration, you may need to remove a RAM chip before you can insert your new ones.
  • Using your finger nail or a spudger, push the lock clips off the RAM chip.
  • Normally the clips can be done one at a time, but may require you to release both at once.
  • Once released, the chip should spring up and can be removed.

Depending on your machines current configuration, you may need to remove a RAM chip before you can insert your new ones.

Using your finger nail or a spudger, push the lock clips off the RAM chip.

Normally the clips can be done one at a time, but may require you to release both at once.

Once released, the chip should spring up and can be removed.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 1 other contributor 


                    Matt

151 Reputation

                                      1 Guide authored                  



                       Badges:
                       7







                                                        +4 more badges