Dell Inspiron 17R N7010 Palm Rest Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          20 minutes

Sections

Battery
2 steps
Palm Rest
4 steps

Flags

BackDell Inspiron 17R-N7010
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

Before using this guide, make sure that the computer is powered off and that you are in a clean and clear workspace where it will be easy to keep track of all parts.

This guide requires basic knowledge of how to use tools like a screwdriver and a spudger. Remember to take your time when using the spudger and to not rush. It may take longer but you will get the job done right if you take your time when attempting this guide.

What you need

Step 1

              Battery

Flip over the laptop so the back is facing upwards.
Locate the battery compartment.
Make sure your laptop is turned off before disassembly.

Flip over the laptop so the back is facing upwards.

Locate the battery compartment.

Make sure your laptop is turned off before disassembly.

1024

Step 2

Slide both locks away from the center of the battery.
After you hear a click, pull out the battery.

Slide both locks away from the center of the battery.

After you hear a click, pull out the battery.

Step 3

              Palm Rest

Remove the four screws from the back panel.
Flip the laptop over and open it to view the keyboard.
Disconnect the keyboard from the laptop by lifting up the latch holding the ribbon cable in place.

Remove the four screws from the back panel.

Flip the laptop over and open it to view the keyboard.

Disconnect the keyboard from the laptop by lifting up the latch holding the ribbon cable in place.

Step 4

Close the laptop and flip it over so the bottom is facing upwards.
Remove the two screws from the small panel.
Remove the small back panel.
Slide the CD drive out of the laptop.
Remove the three screws from the CD drive slot.

Close the laptop and flip it over so the bottom is facing upwards.

Remove the two screws from the small panel.

Remove the small back panel.

Slide the CD drive out of the laptop.

Remove the three screws from the CD drive slot.

Step 5

This step is tricky and can feel like you are breaking the laptop. Follow the next steps with caution to avoid damaging the laptop.
Remove the top cover by inserting a spudger under the surface.
Working clockwise, pry upwards with the spudger to detach the clips.

This step is tricky and can feel like you are breaking the laptop. Follow the next steps with caution to avoid damaging the laptop.

Remove the top cover by inserting a spudger under the surface.

Working clockwise, pry upwards with the spudger to detach the clips.

Step 6

Disconnect the ribbon cables.
Remove the cover to access the inner hardware of the laptop.

Disconnect the ribbon cables.

Remove the cover to access the inner hardware of the laptop.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 9 other contributors

                    Brandon Lopez

Member since: 09/21/2018

319 Reputation

                                      3 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       University of North Texas, Team S8-G5, Riccardelli Fall 2018                        

                                                  Member of University of North Texas, Team S8-G5, Riccardelli Fall 2018 



                    UNT-RICCARDELLI-F18S8G5                     


                                            4 Members                     


                                            5 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team