Dell Inspiron 15 7591 2 In 1 Battery Replacement Repair Guide

Difficulty

Easy

Steps

4

Time Required

                          10 minutes            

Sections

1

• Battery
• 4 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

• BackDell Inspiron 15 7591 2-in-1

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Opening the Laptop               

• Unscrew the 7 Philips #000 screws.
• Loosen the 2 Philips #000 screws. These screws do not come out but rather stay attached to the case.
• With a suction cup lift the top and insert a plastic pry tool or guitar pick. Slide the pry tool from left to right. The panel should pop out slightly.
• Work downwards with a pry tool on the right and left sides. The panel should pop up and be able to be removed.

Unscrew the 7 Philips #000 screws.

Loosen the 2 Philips #000 screws. These screws do not come out but rather stay attached to the case.

With a suction cup lift the top and insert a plastic pry tool or guitar pick. Slide the pry tool from left to right. The panel should pop out slightly.

Work downwards with a pry tool on the right and left sides. The panel should pop up and be able to be removed.

1024

Step 2

              Removing the Battery               

• Remove the 2 Philips #000 screws.
• Loosen the Philips #000 screws. The screw is attached to the battery and will remain attached to the battery.

Remove the 2 Philips #000 screws.

Loosen the Philips #000 screws. The screw is attached to the battery and will remain attached to the battery.

Step 3

              Disconnecting the Battery               

• Flip the battery upside down onto the motherboard.
• Snake the wire out of its housing.
• Disconnect the power connector.

Flip the battery upside down onto the motherboard.

Snake the wire out of its housing.

Disconnect the power connector.

Step 4

• Slide the battery in with the bottom first in order to attach the latches that are at the bottom.
• Screw in the 2 Phillips #000 screws and tighten the 1 Phillips #000 screw attached to the battery.

Slide the battery in with the bottom first in order to attach the latches that are at the bottom.

Screw in the 2 Phillips #000 screws and tighten the 1 Phillips #000 screw attached to the battery.

To reassemble your device, follow these instructions in reverse order. When re-attaching the bottom panel be careful when tightening the screws near the trackpad. If these screws are over tightened it can prevent the trackpad from being clicked.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Griffin Nott                     

Member since: 04/29/2022

181 Reputation

                                      2 Guides authored                  



                       Badges:
                       1