Dell Inspiron 15 7579 Ram Memory Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 minutes

Sections

Back Panel
2 steps
RAM (Memory)
4 steps

Flags

BackDell Inspiron 15 7579
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Panel

Remove the ten 7.9 mm screws with the Phillips PH0 screwdriver.

Remove the ten 7.9 mm screws with the Phillips PH0 screwdriver.

1024

Step 2

Insert metal spudger into a gap in between the back panel and the back of the screen.
Pry off the back panel using the metal spudger as a lever, and remove the back panel by lifting the rest off by hand.

Insert metal spudger into a gap in between the back panel and the back of the screen.

Pry off the back panel using the metal spudger as a lever, and remove the back panel by lifting the rest off by hand.

Step 3

              RAM (Memory)

Fold protective flaps to the side on the RAM module located in the upper right corner of the laptop.

Fold protective flaps to the side on the RAM module located in the upper right corner of the laptop.

Step 4

Use the tweezers to push the crimping metal away from the chip. The chip will pop up into an angled position.
Remove the chip by pulling at the same angle as the chip with the tweezers.

Use the tweezers to push the crimping metal away from the chip. The chip will pop up into an angled position.

Remove the chip by pulling at the same angle as the chip with the tweezers.

Step 5

Fold the plastic flap over on the other side.
As before, pull the fasteners away from the chip with the tweezers.
Remove the chip by carefully pulling it out with the tweezers.

Fold the plastic flap over on the other side.

As before, pull the fasteners away from the chip with the tweezers.

Remove the chip by carefully pulling it out with the tweezers.

Step 6

When reassembling, you must match the notch in the card with the notch in the connector header shown in red.
Doing otherwise will break the stick if forced.

When reassembling, you must match the notch in the card with the notch in the connector header shown in red.

Doing otherwise will break the stick if forced.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors

                    Inaki Madrigal

Member since: 04/23/2018

730 Reputation

                                      6 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Cal Poly, Team S24-G9, Maness Spring 2018                        

                                                  Member of Cal Poly, Team S24-G9, Maness Spring 2018 



                    CPSU-MANESS-S18S24G9                     


                                            4 Members                     


                                            6 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team