Difficulty

Moderate

Steps

9

Time Required

                          15 - 20 minutes

Sections

2

  • Battery
  • 6 steps
  • Touchpad
  • 3 steps

Flags

0

  • BackDell Inspiron 15-7567

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Turn off laptop before beginning.
  • Place the laptop upside down on a flat, stable surface.

Turn off laptop before beginning.

Place the laptop upside down on a flat, stable surface.

1024

Step 2

  • Remove the 3mm screw in the location shown, using a Phillips #1 screwdriver.

Remove the 3mm screw in the location shown, using a Phillips #1 screwdriver.

Step 3

  • Remove the panel from the sides and pull it out at an angle towards you.

Remove the panel from the sides and pull it out at an angle towards you.

Step 4

  • Remove the five 3mm screws on the battery with a Torx (T8) screwdriver in the locations shown.

Remove the five 3mm screws on the battery with a Torx (T8) screwdriver in the locations shown.

Step 5

  • Disconnect the power cord from the battery by using a pair of tweezers, your fingers, or the opening tools from the iFixit pro tech tool kit.
  • Pinch the clips on the left and right side while pulling on the cord at the same time.

Disconnect the power cord from the battery by using a pair of tweezers, your fingers, or the opening tools from the iFixit pro tech tool kit.

Pinch the clips on the left and right side while pulling on the cord at the same time.

Step 6

  • Pull the battery towards you.
  • Make sure to pull at an upward angle.

Pull the battery towards you.

Make sure to pull at an upward angle.

Step 7

              Touchpad
  • Remove the clip holding the power cord on the Touch Pad by using tweezers, your fingers, or iFixit removing tools to gently pull up on the clip.
  • This should release the power cord as shown.

Remove the clip holding the power cord on the Touch Pad by using tweezers, your fingers, or iFixit removing tools to gently pull up on the clip.

This should release the power cord as shown.

Step 8

  • Remove the four 3mm screws using a Phillips #1 screwdriver in the locations shown.

Remove the four 3mm screws using a Phillips #1 screwdriver in the locations shown.

Step 9

  • Remove Touch Pad by pulling towards you gently at a slight upward angle.
  • The Touch Pad is now removed and ready to be replaced.

Remove Touch Pad by pulling towards you gently at a slight upward angle.

The Touch Pad is now removed and ready to be replaced.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 4 other contributors 


                    Dallas Lamorie

Member since: 09/30/2018

523 Reputation

                                      3 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Oregon Institute of Technology, Team S1-G1, Lancaster Fall 2018                        

                                                  Member of Oregon Institute of Technology, Team S1-G1, Lancaster Fall 2018 



                    OIT-LANCASTER-F18S1G1                     


                                            3 Members                     


                                            5 Guides authored