Difficulty
Moderate
Steps
10
Time Required
10 - 35 minutes
Sections
1
- Display Assembly
- 10 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackDell Inspiron 14z N114z
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Remove the Screws
- WARNING: Before working inside your computer, read the safety information that shipped with your computer. Follow the instructions in “Before You Begin”.
- CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on your computer).
- Remove the two screws that secure the display assembly to the computer base.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. Follow the instructions in “Before You Begin”.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on your computer).
Remove the two screws that secure the display assembly to the computer base.
1024
Step 2
Turn over the Computer
- Turn the computer over and open the display as far as possible.
Turn the computer over and open the display as far as possible.
Step 3
Lifting the Connector Latch
- Lift the connector latch and disconnect the display cable from the connector on the system board.
Lift the connector latch and disconnect the display cable from the connector on the system board.
Step 4
Note the Routing
- Note the routing of the display, camera, and mini-card antenna cables, and remove the cables from their routing guides.
Note the routing of the display, camera, and mini-card antenna cables, and remove the cables from their routing guides.
Step 5
Remove the Screws
- Remove the two screws that secure the display assembly to the computer base.
Step 6
Lifting the Display Assembly
- Lift the display assembly off the computer base.
Lift the display assembly off the computer base.
Step 7
Placing the Display Assembly
- Place the NEW display assembly in position and replace the two screws that secure the display assembly to the computer base.
- NOTE: Ensure that no cables are caught between the display assembly and the computer base.
Place the NEW display assembly in position and replace the two screws that secure the display assembly to the computer base.
NOTE: Ensure that no cables are caught between the display assembly and the computer base.
Step 8
Route the Cables
- Route the display, camera, and mini-card antenna cables through their routing guides.
Route the display, camera, and mini-card antenna cables through their routing guides.
Step 9
Sliding the Display Cable
- Slide the display cable in the connector on the system board and press down the latch to secure the cable.
Slide the display cable in the connector on the system board and press down the latch to secure the cable.
Step 10
Replace the Screws
- Turn the computer over.
- Replace the two screws that secure the display assembly to the computer base.
Turn the computer over.
Replace the two screws that secure the display assembly to the computer base.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Terrence15
Member since: 12/18/2017
78,526 Reputation
441 Guides authored
Badges:
28
+25 more badges
Team
Informative Technologies Inc.
Member of Informative Technologies Inc.
Community
38 Members
1,980 Guides authored
