Difficulty

Moderate

Steps

8

Time Required

                          9 - 20 minutes

Sections

1

  • Display Assembly
  • 8 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackDell Inspiron 1410

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Removing the Mylar Tape
  • Before working inside your computer, read the safety information that shipped with your computer. Follow the instructions in Before Working Inside Your Computer.
  • Remove the mylar tapes and then remove the two screws from the back of the computer.

Before working inside your computer, read the safety information that shipped with your computer. Follow the instructions in Before Working Inside Your Computer.

Remove the mylar tapes and then remove the two screws from the back of the computer.

1024

Step 2

              Disconnecting the Display Cable
  • NOTE: Note how the display cable is routed through their routing guides.
  • Pull the display cable tab to disconnect the display cable from the system board connector.

NOTE: Note how the display cable is routed through their routing guides.

Pull the display cable tab to disconnect the display cable from the system board connector.

Step 3

              Dislodging the Cables
  • Make note of the cable routing and carefully dislodge the WLAN antenna cables and the rest of the cables from their routing guides. Pull the cables away, so that they are clear of the palm rest.

Make note of the cable routing and carefully dislodge the WLAN antenna cables and the rest of the cables from their routing guides. Pull the cables away, so that they are clear of the palm rest.

Step 4

              Remove the Screws
  • Remove the two screws from either side of the display hinges.

Remove the two screws from either side of the display hinges.

Step 5

              Removing the Display Assembly
  • Lift and remove the display assembly.

Lift and remove the display assembly.

Step 6

              Placing the Display Assembly
  • Place the NEW display assembly in place and replace the two screws on each side of the display hinges.

Place the NEW display assembly in place and replace the two screws on each side of the display hinges.

Step 7

              Connecting the Display Cable
  • Re-route and connect the display cable to the connector on the system board.

Re-route and connect the display cable to the connector on the system board.

Step 8

              Routing the Antenna Cables
  • Carefully route the WLAN antenna cables into their routing guides on the palm rest and through the computer base.

Carefully route the WLAN antenna cables into their routing guides on the palm rest and through the computer base.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Terrence15

Member since: 12/18/2017

78,526 Reputation

                                      441 Guides authored                  



                       Badges:
                       28







                                                        +25 more badges

Team

                       Informative Technologies Inc.                        

                                                  Member of Informative Technologies Inc. 



                    Community                     


                                            38 Members                     


                                            1,980 Guides authored