Difficulty
Easy
Steps
10
Time Required
15 - 35 minutes
Sections
1
- Display Assembly
- 10 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackDell Inspiron 14 7460
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Remove the Antenna Cables
- WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before Working Inside Your Computer. After working inside your computer, follow the instructions in After Working Inside Your Computer.
- Note the routing and remove the antenna cables from the routing guides on the fan.
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before Working Inside Your Computer. After working inside your computer, follow the instructions in After Working Inside Your Computer.
Note the routing and remove the antenna cables from the routing guides on the fan.
1024
Step 2
Disconnecting the Display Cables
- Open the latch and disconnect the display cable from the system board.
Open the latch and disconnect the display cable from the system board.
Step 3
Placing the Computer
- Open the display at an angle of 90 degrees.
- Place the computer on the edge of a table so that the palm rest and keyboard assembly is on the table and the display assembly extends past the table edge with the display hinges facing up.
Open the display at an angle of 90 degrees.
Place the computer on the edge of a table so that the palm rest and keyboard assembly is on the table and the display assembly extends past the table edge with the display hinges facing up.
Step 4
Remove the Screws
- Remove the four screws (M2.5x5) that secure the display hinges to the palm rest and keyboard assembly.
Remove the four screws (M2.5x5) that secure the display hinges to the palm rest and keyboard assembly.
Step 5
Lifting the Display Assembly
- Lift the display assembly off the palm rest and keyboard assembly.
Lift the display assembly off the palm rest and keyboard assembly.
Step 6
Placing the Palm Rest
- Place the palm rest and keyboard assembly on the edge of a table with the keyboard facing down.
Place the palm rest and keyboard assembly on the edge of a table with the keyboard facing down.
Step 7
Align the Screw Holes
- Align the screw holes on the display hinges with the screw holes on the palm rest and keyboard assembly.
Align the screw holes on the display hinges with the screw holes on the palm rest and keyboard assembly.
Step 8
Replace the Screws
- Replace the four screws (M2.5x5) that secure the NEW display assembly to the palm rest and keyboard assembly.
Replace the four screws (M2.5x5) that secure the NEW display assembly to the palm rest and keyboard assembly.
Step 9
Securing the Display Cable
- Close the display and turn the computer over.
- Slide the display cable into the connector on the system board and close the latch to secure the cable.
Close the display and turn the computer over.
Slide the display cable into the connector on the system board and close the latch to secure the cable.
Step 10
Routing the Antenna Cables
- Route the antenna cables through the routing guides on the fan.
Route the antenna cables through the routing guides on the fan.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Terrence15
Member since: 12/18/2017
78,526 Reputation
441 Guides authored
Badges:
28
+25 more badges
Team
Informative Technologies Inc.
Member of Informative Technologies Inc.
Community
38 Members
1,980 Guides authored
