Difficulty

Easy

Steps

9

Time Required

                          7 minutes

Sections

4

  • Base Cover
  • 2 steps
  • Battery
  • 3 steps
  • Speaker
  • 2 steps
  • Coin Cell Battery
  • 2 steps

Flags

0

  • BackDell Inspiron 14-7437

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Base Cover
  • Power off your Dell Inspiron 14-7437 before disassembling.
  • Remove the eight 4.5 mm screws on the back panel of the device using the Phillips 1 Screwdriver.
  • The two 4.5 mm screws in the center under the rubber mount cannot be removed, but can be loosened.

Power off your Dell Inspiron 14-7437 before disassembling.

Remove the eight 4.5 mm screws on the back panel of the device using the Phillips 1 Screwdriver.

The two 4.5 mm screws in the center under the rubber mount cannot be removed, but can be loosened.

1024

Step 2

  • Pry open the back cover using a spudger and slide it along the under the cover.

Pry open the back cover using a spudger and slide it along the under the cover.

Step 3

              Battery
  • Remove the two 2.5 mm screws holding the battery in place using the J000 Phillips Head Screwdriver.

Remove the two 2.5 mm screws holding the battery in place using the J000 Phillips Head Screwdriver.

Step 4

  • Disconnect the ribbon cables from the motherboard.

Disconnect the ribbon cables from the motherboard.

Step 5

  • Lift up and remove the Lithium-Polymer Battery.

Lift up and remove the Lithium-Polymer Battery.

Step 6

              Speaker
  • Disconnect wires from Motherboard by gently pulling up.

Disconnect wires from Motherboard by gently pulling up.

Step 7

  • Remove the speakers from the case.

Remove the speakers from the case.

Step 8

              Coin Cell Battery
  • Lift the coin cell battery wire, and carefully remove from motherboard.
  • There are little hooks that the wire is hooked under.

Lift the coin cell battery wire, and carefully remove from motherboard.

There are little hooks that the wire is hooked under.

Step 9

  • Remove the Coin-Cell Battery from the case.
  • There is a small amount of adhesive on the bottom of the coin cell battery.

Remove the Coin-Cell Battery from the case.

There is a small amount of adhesive on the bottom of the coin cell battery.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    Katelyn Remy

Member since: 03/10/2016

449 Reputation

                                      4 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       UMass Dartmouth, Team 7-8, Catania Spring 2016                        

                                                  Member of UMass Dartmouth, Team 7-8, Catania Spring 2016 



                    UMASSD-CATANIA-S16S7G8                     


                                            3 Members                     


                                            12 Guides authored