Dell Inspiron 13Z N311Z Display Assembly Replacement Repair Guide

Difficulty

Easy

Steps

9

Time Required

                          3 - 10 minutes            

Sections

1

• Display Assembly
• 9 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

• BackDell Inspiron 13z N311z

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Remove the Screws               

• Follow the instructions in “Before You Begin”.
• Remove the two screws that secure the display panel to the chassis.

Follow the instructions in “Before You Begin”.

Remove the two screws that secure the display panel to the chassis.

1024

Step 2

              Open the Display               

• Turn the computer over and open the display as far as possible.

Turn the computer over and open the display as far as possible.

Step 3

              Remove the Cables               

• Make a note of the routing of the Mini-Card antenna cables and the display cables. Remove the cables from the routing guides.

Make a note of the routing of the Mini-Card antenna cables and the display cables. Remove the cables from the routing guides.

Step 4

              Remove the Screws               

• Remove the two screws (one on each side) that secure the display assembly to the computer base.

Remove the two screws (one on each side) that secure the display assembly to the computer base.

Step 5

              Disconnect the Display Cable               

• Make a note of the cable routing and disconnect the display cable and the wireless card antenna cables from the connectors on the Mini-Card.

Make a note of the cable routing and disconnect the display cable and the wireless card antenna cables from the connectors on the Mini-Card.

Step 6

              Removing the Display Assembly               

• Lift and remove the display assembly off the computer base.

Lift and remove the display assembly off the computer base.

Step 7

              Replace the Screws               

• Place the NEW display assembly in position and replace the two screws (one on each side) that secure the display assembly to the computer base.

Place the NEW display assembly in position and replace the two screws (one on each side) that secure the display assembly to the computer base.

Step 8

              Routing the Cables               

• Route the Mini-Card antenna cables and the display cable through the slot on the computer base.

Route the Mini-Card antenna cables and the display cable through the slot on the computer base.

Step 9

              Connecting the Display Cable               

• Connect the display cable to the connector on the system board.

Connect the display cable to the connector on the system board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Terrence15                     

Member since: 12/18/2017

78,526 Reputation

                                      441 Guides authored                  



                       Badges:
                       28







                                                        +25 more badges                           

Team

                       Informative Technologies Inc.                        

                                                  Member of Informative Technologies Inc. 



                    Community                     


                                            38 Members                     


                                            1,980 Guides authored