Dell Inspiron 13 7359 Wlan Adaptor Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 - 15 minutes

Sections

Battery
4 steps
WLAN Adaptor
3 steps

Flags

BackDell Inspiron 13-7359
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

First flip over the laptop to expose the back panel
Use a Phillips #0 screwdriver to unscrew all ten 7mm Phillips head screws holding the back panel in place.

First flip over the laptop to expose the back panel

Use a Phillips #0 screwdriver to unscrew all ten 7mm Phillips head screws holding the back panel in place.

1024

Step 2

With a plastic spudger, carefully remove the back panel by prying each corner off individually
Slowly pick up the panel and set it aside

With a plastic spudger, carefully remove the back panel by prying each corner off individually

Slowly pick up the panel and set it aside

Step 3

The battery will be the largest black component in the device located near the bottom edge. Using a Phillips #0 screwdriver, unscrew the two 3mm Phillips head screws holding in the battery.

The battery will be the largest black component in the device located near the bottom edge. Using a Phillips #0 screwdriver, unscrew the two 3mm Phillips head screws holding in the battery.

Step 4

To remove the old battery, slightly lift the bottom edge of the battery with your hands
Now slowly pull the battery towards you to fully detach the battery

To remove the old battery, slightly lift the bottom edge of the battery with your hands

Now slowly pull the battery towards you to fully detach the battery

Step 5

              WLAN Adaptor

Unhook both of the wires attached to the WLAN adaptor.

Unhook both of the wires attached to the WLAN adaptor.

Step 6

Remove the 3.9mm Phillips screw using Phillips #0 screwdriver.
Once the screw is removed, one end of the WLAN adaptor will raise up.

Remove the 3.9mm Phillips screw using Phillips #0 screwdriver.

Once the screw is removed, one end of the WLAN adaptor will raise up.

Step 7

Gently remove the WLAN adaptor.

Gently remove the WLAN adaptor.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor

                    Bo Yi Lim

Member since: 04/02/2019

205 Reputation

                                      2 Guides authored                  



                       Badges:
                       3

Team

                       IUPUI, Team S3-G4, Harley Spring 2019                        

                                                  Member of IUPUI, Team S3-G4, Harley Spring 2019 



                    IUPUI-HARLEY-S19S3G4                     


                                            3 Members                     


                                            2 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team