Difficulty
Easy
Steps
11
Time Required
10 - 30 minutes
Sections
1
- Display Assembly
- 11 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackDell Inspiron 13-5378
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Peeling the Tape
- WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before Working Inside Your Computer. After working inside your computer, follow the instructions in After Working Inside Your Computer.
- Peel off the pieces of tape that secure the display cable and touch-screen board-cable to the system board.
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before Working Inside Your Computer. After working inside your computer, follow the instructions in After Working Inside Your Computer.
Peel off the pieces of tape that secure the display cable and touch-screen board-cable to the system board.
1024
Step 2
Open the Latches
- Open the latches to disconnect the display cable and the touch-screen board-cable from the system board.
Open the latches to disconnect the display cable and the touch-screen board-cable from the system board.
Step 3
Open the Display
- Turn the computer over and open the display as far as possible.
Turn the computer over and open the display as far as possible.
Step 4
Placing the Computer
- CAUTION: Place the computer on a soft and clean surface to avoid scratching the display.
- Place the computer face down on a flat surface.
CAUTION: Place the computer on a soft and clean surface to avoid scratching the display.
Place the computer face down on a flat surface.
Step 5
Remove the Screws
- Remove the screws that secure the display assembly to the palm-rest assembly.
Remove the screws that secure the display assembly to the palm-rest assembly.
Step 6
Lifting the Display Assembly
- Lift the display assembly off the palm-rest assembly.
Lift the display assembly off the palm-rest assembly.
Step 7
Placing the Display Assembly
- Place the NEW display assembly face down on the palm-rest assembly.
Place the NEW display assembly face down on the palm-rest assembly.
Step 8
Align the Screw Holes
- Align the screw holes on the display hinges with the screw holes on the palm-rest assembly.
Align the screw holes on the display hinges with the screw holes on the palm-rest assembly.
Step 9
Close the Display
- Close the display and turn the computer over.
Close the display and turn the computer over.
Step 10
Sliding the Display Cable
- Slide the display cable and the touch-screen board-cable into their respective connectors on the system board and close the latches to secure the cables.
Slide the display cable and the touch-screen board-cable into their respective connectors on the system board and close the latches to secure the cables.
Step 11
Adhering the Pieces
- Adhere the pieces of tape that secure the display cable and the touch-screen board-cable to their respective connectors on the system board.
Adhere the pieces of tape that secure the display cable and the touch-screen board-cable to their respective connectors on the system board.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Terrence15
Member since: 12/18/2017
78,526 Reputation
441 Guides authored
Badges:
28
+25 more badges
Team
Informative Technologies Inc.
Member of Informative Technologies Inc.
Community
38 Members
1,980 Guides authored