Dell Inspiron 1122 M102Z Display Assembly Replacement Repair Guide

Difficulty

Easy

Steps

9

Time Required

                          9 - 20 minutes            

Sections

1

• Display Assembly
• 9 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

• BackDell Inspiron 1122 M102z

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Disconnecting the Mini-Card Antenna Cables               

• Follow the instructions in Before You Begin.
• Disconnect the Mini-Card antenna cables from the Mini-Card(s).

Follow the instructions in Before You Begin.

Disconnect the Mini-Card antenna cables from the Mini-Card(s).

1024

Step 2

              Dislodging the Mini-Card Antenna Cables               

• Make note of the cable routing and carefully dislodge the Mini-Card antenna cables from the routing guides.

Make note of the cable routing and carefully dislodge the Mini-Card antenna cables from the routing guides.

Step 3

              Disconnecting the Display Cable               

• Disconnect the display cable from the system board connector.

Disconnect the display cable from the system board connector.

Step 4

              Remove the Screws               

• Remove the two screws (one on each side) that secure the display assembly to the computer base.

Remove the two screws (one on each side) that secure the display assembly to the computer base.

Step 5

              Removing the Display Assembly               

• Lift and remove the display assembly off the computer base.

Lift and remove the display assembly off the computer base.

Step 6

              Placing the Display Assembly               

• Place the NEW display assembly in position and replace the two screws (one on each side) that secure the display assembly to the computer base.

Place the NEW display assembly in position and replace the two screws (one on each side) that secure the display assembly to the computer base.

Step 7

              Connecting the Display Cable               

• Connect the display cable to the system board connector.

Connect the display cable to the system board connector.

Step 8

              Routing the Mini-Card Cables               

• Route the Mini-Card antenna cables through the routing guides on the computer base.

Route the Mini-Card antenna cables through the routing guides on the computer base.

Step 9

              Conencting the Mini-Card Antenna Cables               

• Connect the Mini-Card antenna cables to the Mini-Card(s).

Connect the Mini-Card antenna cables to the Mini-Card(s).

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Terrence15                     

Member since: 12/18/2017

78,526 Reputation

                                      441 Guides authored                  



                       Badges:
                       28







                                                        +25 more badges                           

Team

                       Informative Technologies Inc.                        

                                                  Member of Informative Technologies Inc. 



                    Community                     


                                            38 Members                     


                                            1,980 Guides authored