Dell Inspiron 1100 Display Assembly Removal Repair Guide

Difficulty

Easy

Steps

5

Time Required

                          10 - 20 minutes            

Sections

1

• Display Assembly
• 5 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

• BackDell Inspiron 1100

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Remove the Screws               

• Follow the instructions in “Preparing to Work Inside the Computer.”
• CAUTION: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer’s electronic components. You can do so by touching an unpainted metal surface.
• Close the display.
• From the back of the computer, remove the two M2.5 x 5-mm screws labeled “circle D.”

Follow the instructions in “Preparing to Work Inside the Computer.”

CAUTION: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer’s electronic components. You can do so by touching an unpainted metal surface.

Close the display.

From the back of the computer, remove the two M2.5 x 5-mm screws labeled “circle D.”

1024

Step 2

              Opening the Display Assembly               

• Open the display assembly approximately 180 degrees, and support the display assembly so that it does not open past this position.

Open the display assembly approximately 180 degrees, and support the display assembly so that it does not open past this position.

Step 3

              Remove the Screws               

• Remove the two M2.5 x 5-mm screws from each hinge bracket.

Remove the two M2.5 x 5-mm screws from each hinge bracket.

Step 4

              Disconnecting the Cable               

• Pull straight up on the pull-tab that is attached to the display-feed flex cable to disconnect the cable from the system board.

Pull straight up on the pull-tab that is attached to the display-feed flex cable to disconnect the cable from the system board.

Step 5

              Lifting the Display Assembly               

• Lift the display assembly up and out of the computer base.

Lift the display assembly up and out of the computer base.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Terrence15                     

Member since: 12/18/2017

78,526 Reputation

                                      441 Guides authored                  



                       Badges:
                       28







                                                        +25 more badges                           

Team

                       Informative Technologies Inc.                        

                                                  Member of Informative Technologies Inc. 



                    Community                     


                                            38 Members                     


                                            1,980 Guides authored