Difficulty

Easy

Steps

5

Time Required

                          10 minutes

Sections

2

  • Stand
  • 2 steps
  • Display Bezel
  • 3 steps

Flags

0

  • BackDell E193FPc

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Stand
  • Lay the monitor screen-down so the back screws are exposed.
  • Remove the four 11.9 mm Phillips #2 screws securing the stand to the back of the monitor.

Lay the monitor screen-down so the back screws are exposed.

Remove the four 11.9 mm Phillips #2 screws securing the stand to the back of the monitor.

1024

Step 2

  • Gently lift and pull away the stand at a slight angle away from the monitor.

Gently lift and pull away the stand at a slight angle away from the monitor.

Step 3

              Display Bezel
  • Locate the two holes on the bottom of the monitor.
  • Insert a plastic opening tool or spudger into the holes and gently pry the plastic apart along the groove.
  • This task is much easier if two people pry simultaneously at each hole.
  • Continue prying along the entire edge of the monitor.

Locate the two holes on the bottom of the monitor.

Insert a plastic opening tool or spudger into the holes and gently pry the plastic apart along the groove.

This task is much easier if two people pry simultaneously at each hole.

Continue prying along the entire edge of the monitor.

Step 4

  • When finished prying, the plastic will partially fall away from the rest of the monitor.
  • Do not try to fully remove the front frame yet. The frame is still attached to the buttons.
  • While holding the frames together, carefully flip the monitor over so it faces screen down.
  • Gently lift and remove remove the rear case from the monitor.

When finished prying, the plastic will partially fall away from the rest of the monitor.

Do not try to fully remove the front frame yet. The frame is still attached to the buttons.

While holding the frames together, carefully flip the monitor over so it faces screen down.

Gently lift and remove remove the rear case from the monitor.

Step 5

  • Locate the green interface button board.
  • Remove the three 9.71 mm Phillips #2 screws holding the interface button board to the display bezel.
  • Lift the monitor interior away from the front cover.

Locate the green interface button board.

Remove the three 9.71 mm Phillips #2 screws holding the interface button board to the display bezel.

Lift the monitor interior away from the front cover.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      5 other people completed this guide.

Author

                                      with 5 other contributors 


                    Mackenzie Keane

Member since: 10/04/2011

514 Reputation

                                      5 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       Cal Poly, Team 5-36, Amido Fall 2011                        

                                                  Member of Cal Poly, Team 5-36, Amido Fall 2011 



                    CPSU-AMIDO-F11S5G36                     


                                            4 Members                     


                                            6 Guides authored