Difficulty

Moderate

Steps

8

Time Required

                          5 minutes

Sections

3

  • Back Cover
  • 2 steps
  • Battery
  • 3 steps
  • Speaker
  • 3 steps

Flags

0

  • BackDell Chromebook 3100 2-in-1

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Before using this guide, check the speaker for blockage that may be interfering with the sound. Usually, dust and debris can be cleared by a small dust blower. Make sure to check that the volume is not muted to confirm it needs replacing.

To begin this guide, check that the Chromebook’s power is off and disconnected from any power source.

It is not necessary to remove the battery; instead, the battery connector can be disconnected to isolate power to the system.

What you need

Step 1

              Back Cover
  • Using a Phillips #1 screwdriver, remove all nine of the 5 mm screws from the back cover.

Using a Phillips #1 screwdriver, remove all nine of the 5 mm screws from the back cover.

1024

Step 2

  • Use the opening tool to pry the back cover off of the device.

Use the opening tool to pry the back cover off of the device.

Step 3

              Battery
  • Disconnect the battery cable from the connector on the system board.

Disconnect the battery cable from the connector on the system board.

Step 4

  • Using a Phillips #1 screwdriver, remove the three 4 mm screws that secure the battery.
  • Remove the adhesive tape that secures the battery in place.

Using a Phillips #1 screwdriver, remove the three 4 mm screws that secure the battery.

Remove the adhesive tape that secures the battery in place.

Step 5

  • Carefully remove the battery from the device.

Carefully remove the battery from the device.

Step 6

              Speaker
  • Remove adhesive tape that secures the speaker cable.
  • Disconnect the speaker cable from the connector on the system board.

Remove adhesive tape that secures the speaker cable.

Disconnect the speaker cable from the connector on the system board.

Step 7

  • Remove the speaker cable from the retention clips.

Remove the speaker cable from the retention clips.

Step 8

  • Lift and remove the speakers from the device.

Lift and remove the speakers from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    M Ali

Member since: 11/03/2021

253 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       Gateway, Team 1-1, Pee Fall 2021                        

                                                  Member of Gateway, Team 1-1, Pee Fall 2021 



                    GCC-PEE-F21S1G1                     


                                            5 Members                     


                                            5 Guides authored