Difficulty

Easy

Steps

8

Time Required

                          5 minutes

Sections

3

  • Back Panel
  • 2 steps
  • Battery
  • 2 steps
  • Speakers
  • 4 steps

Flags

0

  • BackDell Chromebook 11-3120

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Panel
  • Use the #J0 screwdriver to unscrew the seven 4mm screws located around the back panel.

Use the #J0 screwdriver to unscrew the seven 4mm screws located around the back panel.

1024

Step 2

  • Use the plastic opening tool to gently pry around the four sides of the back panel until the panel is fully released.
  • Taking the back cover off of the computer may require more force than expected. When using the opening tool, be careful not to use too much force on it, and make sure all the screws are removed.

Use the plastic opening tool to gently pry around the four sides of the back panel until the panel is fully released.

Taking the back cover off of the computer may require more force than expected. When using the opening tool, be careful not to use too much force on it, and make sure all the screws are removed.

Step 3

              Battery
  • Using a JIS #0 screwdriver, unscrew the two 4mm screws securing the battery in place.

Using a JIS #0 screwdriver, unscrew the two 4mm screws securing the battery in place.

Step 4

  • Using the pointed end of a #2 spudger, remove the connection between the battery and motherboard by slightly pulling on the wires while pushing the tiny hole down using the spudger.
  • Pull out the battery from inside the laptop.

Using the pointed end of a #2 spudger, remove the connection between the battery and motherboard by slightly pulling on the wires while pushing the tiny hole down using the spudger.

Pull out the battery from inside the laptop.

Step 5

              Speakers
  • Gently remove the 4-pin connector that connects the speakers to the motherboard.

Gently remove the 4-pin connector that connects the speakers to the motherboard.

Step 6

  • Remove the tape securing it to the plastic casing of the device.

Remove the tape securing it to the plastic casing of the device.

Step 7

  • Carefully lift out the right speaker housing, which is held in place by circular rubber guides, located on both sides of the housing.

Carefully lift out the right speaker housing, which is held in place by circular rubber guides, located on both sides of the housing.

Step 8

  • Moving down the cable, remove the left speaker housing, which is held in place by circular rubber guides, located on both sides of the housing.

Moving down the cable, remove the left speaker housing, which is held in place by circular rubber guides, located on both sides of the housing.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    Joseph Silveira

Member since: 10/19/2017

401 Reputation

                                      3 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       UMass Dartmouth, Team S4-G1, Julie Fall 2017                        

                                                  Member of UMass Dartmouth, Team S4-G1, Julie Fall 2017 



                    UMASSD-JULIE-F17S4G1                     


                                            3 Members                     


                                            6 Guides authored