Dell 1908Fpc Monitor Usb Hard Drive Replacement Repair Guide

Difficulty

Moderate

Steps

5

Time Required

                          35 minutes            

Sections

1

• USB Motherboard
• 5 steps

Flags

0

• BackDell 1908FPc Monitor

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              USB Motherboard               

• Pop the front bezel off by inserting fingers underneath the left or right inside edge of screen.
• Do not try to remove the bezel completely as there is a ribbon cable attached to the bottom for the buttons located in the bottom right hand corner.
• A lot of pressure is required to remove the bezel. Do not be afraid of asserting some force.

Pop the front bezel off by inserting fingers underneath the left or right inside edge of screen.

Do not try to remove the bezel completely as there is a ribbon cable attached to the bottom for the buttons located in the bottom right hand corner.

A lot of pressure is required to remove the bezel. Do not be afraid of asserting some force.

1024

Step 2

• Turn the monitor over. Unscrew the four 4mm x 10mm screws on the back of the monitor and remove the plastic backing.

Turn the monitor over. Unscrew the four 4mm x 10mm screws on the back of the monitor and remove the plastic backing.

Step 3

• Unscrew the 3mm x 4mm screw that retains the side USB shield.
• Remove shield and set aside.

Unscrew the 3mm x 4mm screw that retains the side USB shield.

Remove shield and set aside.

Step 4

• Remove the five 3mm x 2mm screws that retain the metal cover protecting the electronics.
• Remove the four 2.75mm x 6.75mm studs by the video imput ports.
• Slide the cover downwards to unlock and remove cover.

Remove the five 3mm x 2mm screws that retain the metal cover protecting the electronics.

Remove the four 2.75mm x 6.75mm studs by the video imput ports.

Slide the cover downwards to unlock and remove cover.

Step 5

• Unplug board connections.
• Uncsrew the four 3mm x 5.5mm screws that hold the USB motherboard down.
• Get new board ready to install.

Unplug board connections.

Uncsrew the four 3mm x 5.5mm screws that hold the USB motherboard down.

Get new board ready to install.

You now know how to replace the USB motherboard on a Dell 1908FPc monitor.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 2 other contributors 

                    Connor Henshaw                     

Member since: 10/02/2017

128 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       Michigan Tech, Team S3-G9, Galliah Fall 2017                        

                                                  Member of Michigan Tech, Team S3-G9, Galliah Fall 2017 



                    MTU-GALLIAH-F17S3G9                     


                                            1 Member                     


                                            1 Guide authored