Difficulty

Moderate

Steps

6

Time Required

                          20 - 40 minutes

Sections

2

  • Access Panel
  • 4 steps
  • Power Supply
  • 2 steps

Flags

0

  • BackDefinitive Technology W7

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Access Panel
  • Wedge the spudger in any of the four corners of the panel and apply downward pressure on the spudgers handle to pry the panel away from the speaker housing.
  • Repeat this procedure around the perimeter until the panel releases, then lift the panel up by hand.

Wedge the spudger in any of the four corners of the panel and apply downward pressure on the spudgers handle to pry the panel away from the speaker housing.

Repeat this procedure around the perimeter until the panel releases, then lift the panel up by hand.

1024

Step 2

  • Remove the thirteen 5 mm Phillips #0 screws.
  • Once all screws have been removed, gently pull up on the black panel to remove it from the top of the speaker.

Remove the thirteen 5 mm Phillips #0 screws.

Once all screws have been removed, gently pull up on the black panel to remove it from the top of the speaker.

Step 3

  • The gray mesh bag covering the speaker will now be exposed.
  • Flick the switch on the middle of the lock down to loosen the sack.
  • Pull upwards on the locking mechanism to loosen the drawstring. Stop pulling when the mesh bag is loose enough that it can be pulled downwards.

The gray mesh bag covering the speaker will now be exposed.

Flick the switch on the middle of the lock down to loosen the sack.

Pull upwards on the locking mechanism to loosen the drawstring. Stop pulling when the mesh bag is loose enough that it can be pulled downwards.

Step 4

  • Remove the four screws on top of the device on each corner with a Phillips #0 screwdriver.
  • Remove the black panel.

Remove the four screws on top of the device on each corner with a Phillips #0 screwdriver.

Remove the black panel.

Step 5

              Power Supply
  • Use a Phillips #2 screwdriver to remove the four 5 mm black screws on the side of the device.

Use a Phillips #2 screwdriver to remove the four 5 mm black screws on the side of the device.

Step 6

  • Unclip the two white connectors from the power supply. This is done by pressing the two white plastic strips on the clip together, then, pulling upwards.
  • If removing the clips from the power supply is difficult by hand, use pliers to press the two white plastic strips together, then pull upwards.

Unclip the two white connectors from the power supply. This is done by pressing the two white plastic strips on the clip together, then, pulling upwards.

If removing the clips from the power supply is difficult by hand, use pliers to press the two white plastic strips together, then pull upwards.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Brendan Thibault

Member since: 10/26/2022

339 Reputation

                                      3 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       UMass Dartmouth, Team 2-5, Petersen Fall 2022                        

                                                  Member of UMass Dartmouth, Team 2-5, Petersen Fall 2022 



                    UMASSD-PETERSEN-F22S2G5                     


                                            4 Members                     


                                            5 Guides authored