Dcc 3200 Faulty Power Cord Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

Suggest a time??

Sections

1

• Faulty Power Cord
• 7 steps

Flags

2

Bullets!

Better coordination with markups and the color/type of bullets will help make this guide more clear!

Better Introduction

Improve this guide by completing or revising its introduction.

• BackCuisinart DCC-3200

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Faulty Power Cord               

• First, please be sure that the device is unplugged and that there is no water in the reservoir.
• Check the power cord for frays or cracks.

First, please be sure that the device is unplugged and that there is no water in the reservoir.

Check the power cord for frays or cracks.

1024

Step 2

• If the cord appears fine, please flip the device upside-down and unscrew the 4 screws on the bottom.

If the cord appears fine, please flip the device upside-down and unscrew the 4 screws on the bottom.

Step 3

• Remove the bottom panel and unclip the power cord from the panel.

Remove the bottom panel and unclip the power cord from the panel.

Step 4

• With the front facing towards you upside down, to the top left of the circular hotplate is a beige circuit board with two screws on either side holding it in. Please unscrew them.

With the front facing towards you upside down, to the top left of the circular hotplate is a beige circuit board with two screws on either side holding it in. Please unscrew them.

Step 5

• Carefully remove the circuit board and unplug the gray ribbon wire that is plugged into it.

Carefully remove the circuit board and unplug the gray ribbon wire that is plugged into it.

Step 6

• Check to see if the power cord is connected properly to the circuit board.

Check to see if the power cord is connected properly to the circuit board.

Step 7

• Strip the wire and twist with the other or solder it back on.

Strip the wire and twist with the other or solder it back on.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 1 other contributor 

                    Hamad Khan                     

Member since: 03/04/2016

379 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges                           

Team

                       UMass Dartmouth, Team 8-3, Botvin Spring 2016                        

                                                  Member of UMass Dartmouth, Team 8-3, Botvin Spring 2016 



                    UMASSD-BOTVIN-S16S8G3                     


                                            3 Members                     


                                            3 Guides authored