Daisy Model 10 Carbine Cocking Lever Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          10 - 15 minutes

Sections

Cocking Lever
2 steps

Flags

BackDaisy Model 10 Carbine
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Removing Screws

Make sure the safety is on!
Place the carbine with the saddle ring and leather thong facing upwards.
Locate the screw head on the cocking lever.
There should be one on either side of the saddle ring and one on the cocking lever assembly.
Place a #2 Phillips Screwdriver in the 11/16ths of an inch, matte black screw on the cocking lever assembly. Twist with a counter-clockwise motion.
Completely remove the screws.
Be wary of the black washers on the other side of the Carbine. Be sure to keep track of them once they fall out after the screws are removed

Make sure the safety is on!

Place the carbine with the saddle ring and leather thong facing upwards.

Locate the screw head on the cocking lever.

There should be one on either side of the saddle ring and one on the cocking lever assembly.

Place a #2 Phillips Screwdriver in the 11/16ths of an inch, matte black screw on the cocking lever assembly. Twist with a counter-clockwise motion.

Completely remove the screws.

Be wary of the black washers on the other side of the Carbine. Be sure to keep track of them once they fall out after the screws are removed

1024

Step 2

              Removing the Lever

Remove the cocking lever by placing your dominant hand’s fingers through the cocking lever handle.
With your fingers in the handle, slide the lever towards the butt of the carbine.
Finally, pull the cocking lever and carbine in opposite directions to replace the cocking lever.

Remove the cocking lever by placing your dominant hand’s fingers through the cocking lever handle.

With your fingers in the handle, slide the lever towards the butt of the carbine.

Finally, pull the cocking lever and carbine in opposite directions to replace the cocking lever.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Timothy Gachot

Member since: 10/12/2014

237 Reputation

                                      2 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Cal Poly, Team 6-20, Maness Fall 2014                        

                                                  Member of Cal Poly, Team 6-20, Maness Fall 2014 



                    CPSU-MANESS-F14S6G20                     


                                            4 Members                     


                                            5 Guides authored

Introduction#

What you need#

#

#

#

#

Team#

#

Introduction

What you need

Team