D Link Hd Wi Fi Camera Microphone Replacement Repair Guide

Difficulty

Easy

Steps

5

Time Required

                          9 minutes            

Sections

2

• Motherboard
• 3 steps
• Microphone
• 2 steps

Flags

0

• BackD-Link HD Wi-Fi Camera (DCS-936L)

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Motherboard               

• Place the camera upwards between your thumb and first finger.
• Tilt the camera to the best position and loosen the captive linings using a plastic opening tool.
• Slide the top cover outwards to separate the upper section from the lower lid using the plastic opening tool.

Place the camera upwards between your thumb and first finger.

Tilt the camera to the best position and loosen the captive linings using a plastic opening tool.

Slide the top cover outwards to separate the upper section from the lower lid using the plastic opening tool.

1024

Step 2

• Remove the 6.0mm Phillips #00 screws that secure the back cover to the inner frame.
• Lift the rear lid upwards using your fingers and separate it from the internal components and motherboard.

Remove the 6.0mm Phillips #00 screws that secure the back cover to the inner frame.

Lift the rear lid upwards using your fingers and separate it from the internal components and motherboard.

Step 3

• Unscrew the motherboard from the frame. There are 3 Phillips #00 5.0mm screws holding it in place.
• Then (gently!) remove the motherboard and the lens with your fingers.

Unscrew the motherboard from the frame. There are 3 Phillips #00 5.0mm screws holding it in place.

Then (gently!) remove the motherboard and the lens with your fingers.

Step 4

              Microphone               

• To remove the front cover, place index finger in the center and pull away from the frame. This may take a little effort, but should not require an opening tool.

To remove the front cover, place index finger in the center and pull away from the frame. This may take a little effort, but should not require an opening tool.

Step 5

• After the cover is removed, unscrew the two Phillips #00 5.0mm screws. Then the board should slide right out.

After the cover is removed, unscrew the two Phillips #00 5.0mm screws. Then the board should slide right out.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Morgen Jaques                     

Member since: 09/28/2017

533 Reputation

                                      5 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       Idaho State University, Team S4-G2, Watkins Fall 2017                        

                                                  Member of Idaho State University, Team S4-G2, Watkins Fall 2017 



                    ISU-WATKINS-F17S4G2                     


                                            3 Members                     


                                            10 Guides authored