Difficulty
Moderate
Steps
4
Time Required
3 - 7 minutes
Sections
2
- Case
- 3 steps
- Heat Sink
- 1 step
Flags
0
BackD-Link DIR-890L
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Case
- Peel off the four rubber rectangular feet with your fingers.
- The feet may be hard to remove. Apply additional force if necessary.
Peel off the four rubber rectangular feet with your fingers.
The feet may be hard to remove. Apply additional force if necessary.
1024
Step 2
- Unscrew the 5mm screws in each corner using the Phillips #1 screwdriver.
Unscrew the 5mm screws in each corner using the Phillips #1 screwdriver.
Step 3
- Wedge the opening tool between the red top panel and the gray bottom panel.
- Twist the opening tool to separate the panels. Work your way around the case until both of the panels are separated.
Wedge the opening tool between the red top panel and the gray bottom panel.
Twist the opening tool to separate the panels. Work your way around the case until both of the panels are separated.
Step 4
Heat Sink
- Unscrew the two 7mm screws with a Phillips #1 screwdriver.
- Lift the heat sink off the metal plate with your fingers.
Unscrew the two 7mm screws with a Phillips #1 screwdriver.
Lift the heat sink off the metal plate with your fingers.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Michael Hilomen
Member since: 10/06/2016
201 Reputation
1 Guide authored
Badges:
12
+9 more badges
Team
Cal Poly, Team 10-7, Livingston Fall 2016
Member of Cal Poly, Team 10-7, Livingston Fall 2016
CPSU-LIVINGSTON-F16S10G7
4 Members
12 Guides authored
