Difficulty

Moderate

Steps

10

Time Required

                          5 minutes

Sections

3

  • Accent Ring
  • 3 steps
  • Back Casing
  • 4 steps
  • LED Light Cover
  • 3 steps

Flags

0

  • BackD-Link DCS-825L

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Accent Ring
  • Grasp the side of the accent ring. There is a notch that your thumb will be able to grab ahold of.

Grasp the side of the accent ring. There is a notch that your thumb will be able to grab ahold of.

1024

Step 2

  • Twist the accent ring until it pops off. You may need to use both hands if the accent ring is stuck.

Twist the accent ring until it pops off. You may need to use both hands if the accent ring is stuck.

Step 3

  • Replace your accent ring with whichever color you choose.

Replace your accent ring with whichever color you choose.

Step 4

              Back Casing
  • Remove one Phillips #2 screw from each side of the camera lens.

Remove one Phillips #2 screw from each side of the camera lens.

Step 5

  • Pull the Wi-Fi Baby Camera open.
  • It should be easily done after the screws are removed.

Pull the Wi-Fi Baby Camera open.

It should be easily done after the screws are removed.

Step 6

  • Take your tweezers and gently pull the white tip out from its plug that is connected to a red and black twisted wire.

Take your tweezers and gently pull the white tip out from its plug that is connected to a red and black twisted wire.

Step 7

  • Take your tweezers and gently pull the white tip that is on the end of the white wire (the antenna) out from its plug in.

Take your tweezers and gently pull the white tip that is on the end of the white wire (the antenna) out from its plug in.

Step 8

              LED Light Cover
  • Grab the white cylinder with your thumb and index finger.

Grab the white cylinder with your thumb and index finger.

Step 9

  • Gently lift the cylinder up from its placement in your Wi-Fi Baby Camera.

Gently lift the cylinder up from its placement in your Wi-Fi Baby Camera.

Step 10

  • Remove the white cylinder completely to replace it.

Remove the white cylinder completely to replace it.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Annalise Leclair

Member since: 10/09/2018

97 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       USF Tampa, Team S1-G5, Leahy Fall 2018                        

                                                  Member of USF Tampa, Team S1-G5, Leahy Fall 2018 



                    USFT-LEAHY-F18S1G5                     


                                            4 Members                     


                                            4 Guides authored