Difficulty
Moderate
Steps
4
Time Required
2 - 3 minutes
Sections
1
- Back casing
- 4 steps
Flags
Better Introduction
Improve this guide by completing or revising its introduction.
BackD-Link DCS-2630L
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Back casing
- Remove the two 9.65 mm screws on the back cover using the Philips head PH00 screw driver.
Remove the two 9.65 mm screws on the back cover using the Philips head PH00 screw driver.
1024
Step 2
- Remove the back casing to expose the circuit board.
Remove the back casing to expose the circuit board.
Step 3
- Detach the gray antenna wires by gently pulling on the side closest to the circuit board.
Detach the gray antenna wires by gently pulling on the side closest to the circuit board.
Step 4
- Detach the speaker wire by gently pulling on the side closest to the body of the camera.
Detach the speaker wire by gently pulling on the side closest to the body of the camera.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 2 other contributors
Collyn Dodge
Member since: 03/21/2018
323 Reputation
2 Guides authored
Badges:
8
+5 more badges
Team
IUPUI, Team S4-G2, Baechle Spring 2018
Member of IUPUI, Team S4-G2, Baechle Spring 2018
IUPUI-BAECHLE-S18S4G2
3 Members
6 Guides authored
