Difficulty
Moderate
Steps
4
Time Required
10 - 15 minutes
Sections
1
- Solar Panel
- 4 steps
Flags
Better Introduction
Improve this guide by completing or revising its introduction.
Backd.light Solar Lantern S2
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Solar Panel
- To remove the lens, three T15 x 12.5mm screws must be removed by a T15 head screwdriver.
- The location of the other two screws are marked in red.
To remove the lens, three T15 x 12.5mm screws must be removed by a T15 head screwdriver.
The location of the other two screws are marked in red.
1024
Step 2
- After the lens has been removed the back cover needs to be removed. There are no snaps or screws holding it in place.
After the lens has been removed the back cover needs to be removed. There are no snaps or screws holding it in place.
Step 3
- Desolder the yellow and black wires that connect the solar panel to the circuit board.
- Remove the solar panel by pressing on the mounting clips (underneath fingers) using the spudger.
Desolder the yellow and black wires that connect the solar panel to the circuit board.
Remove the solar panel by pressing on the mounting clips (underneath fingers) using the spudger.
Step 4
- Solder the wires to the solar panel (positive to positive, negative to negative).
Solder the wires to the solar panel (positive to positive, negative to negative).
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 4 other contributors
Jeremiah Rhoades
Member since: 11/07/2017
411 Reputation
3 Guides authored
Badges:
7
+4 more badges
Team
IUPUI, Team S2-G3, Harley Fall 2017
Member of IUPUI, Team S2-G3, Harley Fall 2017
IUPUI-HARLEY-F17S2G3
3 Members
3 Guides authored