Cyberpowerpc Fangbook Hx6 Screen Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          9 - 10 minutes

Sections

Screen
4 steps

Flags

BackCyberpowerPC Fangbook HX6
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Screen

To replace the screen you will need a screwdriver (a size zero was used in this guide), and a tool that can be used to pry off the screen covering (a spudger was used in this guide).

To replace the screen you will need a screwdriver (a size zero was used in this guide), and a tool that can be used to pry off the screen covering (a spudger was used in this guide).

1024

Step 2

Insert the spudger gently into the seam that connects the front plate to the rest of the device.
Move the tool carefully around the screen and apply a small amount of pressure. You are trying to undo several clasps holding the front plate on.
Do this on all sides of the face plate except for the bottom. The bottom will have a strip of adhesive you will need to carefully pull off to separate the face plate from the bottom of the screen.

Insert the spudger gently into the seam that connects the front plate to the rest of the device.

Move the tool carefully around the screen and apply a small amount of pressure. You are trying to undo several clasps holding the front plate on.

Do this on all sides of the face plate except for the bottom. The bottom will have a strip of adhesive you will need to carefully pull off to separate the face plate from the bottom of the screen.

Step 3

Remove the two 4mm silver screws on both sides of the top of the screen.
Once you have removed them, gently pull the screen off of the aligning dials (the small plastic pieces to the left of the screws).

Remove the two 4mm silver screws on both sides of the top of the screen.

Once you have removed them, gently pull the screen off of the aligning dials (the small plastic pieces to the left of the screws).

Step 4

At this point the only thing keeping the screen attached to the laptop is this small wire and connector shown here.
Gently pull the screen out and turn it over so that you can see where the connector is attached.
Carefully remove it. Once this is done you have successfully removed the screen from your laptop.

At this point the only thing keeping the screen attached to the laptop is this small wire and connector shown here.

Gently pull the screen out and turn it over so that you can see where the connector is attached.

Carefully remove it. Once this is done you have successfully removed the screen from your laptop.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Eric Box

Member since: 09/12/2018

159 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       University of Alabama, Team S1-G4, Bedsole Fall 2018                        

                                                  Member of University of Alabama, Team S1-G4, Bedsole Fall 2018 



                    UA-BEDSOLE-F18S1G4                     


                                            2 Members                     


                                            2 Guides authored

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team