Cuisinart Smart Stick Csb 75 Electrical Cord Replacement Repair Guide

Difficulty

Difficult

Steps

5

Time Required

                          1 hour            

Sections

1

• Electrical Cord
• 5 steps

Flags

0

• BackCuisinart Smart Stick CSB-75

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Electrical Cord               

• Located on the back of the motor body are three screw covers. To remove the three grey screw covers, use a Flat Head Screwdriver (1.0mm or 1.5mm).
• After prying these off, the screws will be exposed.

Located on the back of the motor body are three screw covers. To remove the three grey screw covers, use a Flat Head Screwdriver (1.0mm or 1.5mm).

After prying these off, the screws will be exposed.

1024

Step 2

• Remove three 13.3 mm Phillips PH#2 screws.

Remove three 13.3 mm Phillips PH#2 screws.

Step 3

• Pry open Cuisinart using a plastic opening tool.
• The metal spudger is great when you need serious prying power, but the regular black nylon spudger or a plastic opening tool should be used whenever possible.
• Make sure to pry open near the clips of the smart stick for easy opening.

Pry open Cuisinart using a plastic opening tool.

The metal spudger is great when you need serious prying power, but the regular black nylon spudger or a plastic opening tool should be used whenever possible.

Make sure to pry open near the clips of the smart stick for easy opening.

Step 4

• Unscrew the 4 screws on the inside.
• Remove 2 13.3mm Phillips PH#2 screws.
• Remove 2 17.5 mm Phillips PH#2 screws.
• Unscrewing these screws will isolate the switch board.

Unscrew the 4 screws on the inside.

Remove 2 13.3mm Phillips PH#2 screws.

Remove 2 17.5 mm Phillips PH#2 screws.

Unscrewing these screws will isolate the switch board.

Step 5

• Refer to these steps on Soldering to replace the electrical cord in the smart stick.
• Be careful when soldering; it gets very hot.

Refer to these steps on Soldering to replace the electrical cord in the smart stick.

Be careful when soldering; it gets very hot.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 4 other contributors 

                    Jordan Robinson                     

Member since: 09/02/2015

542 Reputation

                                      4 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       USF Tampa, Team 16-2, Wollert Fall 2015                        

                                                  Member of USF Tampa, Team 16-2, Wollert Fall 2015 



                    USFT-WOLLERT-F15S16G2                     


                                            4 Members                     


                                            4 Guides authored