Difficulty
Difficult
Steps
7
Time Required
45 minutes
Sections
1
- Power Cord
- 7 steps
Flags
0
BackCuisinart CHW-12
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Power Cord
- Unplug the coffee-maker from the power source.
- Use a Phillips head screwdriver to remove the four 7mm screws from the back and the three 8mm screws from the bottom. This will release the bottom cover.
Unplug the coffee-maker from the power source.
Use a Phillips head screwdriver to remove the four 7mm screws from the back and the three 8mm screws from the bottom. This will release the bottom cover.
1024
Step 2
- Use tweezers to remove the two rubber feet marked within the provided pictures.
- Remove both 8mm Phillips head screws found within the holes where the feet were just removed.
Use tweezers to remove the two rubber feet marked within the provided pictures.
Remove both 8mm Phillips head screws found within the holes where the feet were just removed.
Step 3
- Carefully pull the cover off the bottom of the coffee maker. This will give you access to the inside of the coffee maker.
- Pull the gray ribbon cable strait out of the black containment box.
Carefully pull the cover off the bottom of the coffee maker. This will give you access to the inside of the coffee maker.
Pull the gray ribbon cable strait out of the black containment box.
Step 4
- Locate the Phillips head screws holding the highlighted plastic shield in place.
- Remove the two 14mm screws with a Phillips head screwdriver.
- Carefully slide the shield out of place along the power cord and set it aside.
Locate the Phillips head screws holding the highlighted plastic shield in place.
Remove the two 14mm screws with a Phillips head screwdriver.
Carefully slide the shield out of place along the power cord and set it aside.
Step 5
- Remove the two 14mm Phillips head screws securing the plastic containment box.
- Pull the plastic containment box straight out of the coffee maker.
Remove the two 14mm Phillips head screws securing the plastic containment box.
Pull the plastic containment box straight out of the coffee maker.
Step 6
- Remove the four 11mm Phillips head screws in each corner of the plastic containment box.
- Pull the top from the plastic housing.
Remove the four 11mm Phillips head screws in each corner of the plastic containment box.
Pull the top from the plastic housing.
Step 7
- Pull the circuit board out of the containment box.
- Locate the power cable connection point on the circuit board.
- Desolder the power cable wires connected to the board.
- Solder iron can cause burns if used improperly.
- Replace the power cable with the corresponding wires of the new power cable.
Pull the circuit board out of the containment box.
Locate the power cable connection point on the circuit board.
Desolder the power cable wires connected to the board.
Solder iron can cause burns if used improperly.
Replace the power cable with the corresponding wires of the new power cable.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 2 other contributors
Trevor Aspinall
Member since: 03/22/2018
351 Reputation
2 Guides authored
Badges:
9
+6 more badges
Team
Sam Houston State, Team S17-G2, Blackburne Spring 2018
Member of Sam Houston State, Team S17-G2, Blackburne Spring 2018
SHSU-BLACKBURNE-S18S17G2
3 Members
4 Guides authored
