Difficulty

Moderate

Steps

7

Time Required

Suggest a time??

Sections

2

  • Prerequisite Only
  • 6 steps
  • Logic Board
  • 1 step

Flags

3

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Incorrect Tools

Help make this guide better by using the correct tools in images and/or text.

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • BackCreative Zen V Plus

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Prerequisite Only
  • Find the grooves around the buttons on the front and carefully remove the panel. This can be done without the use of any tools.

Find the grooves around the buttons on the front and carefully remove the panel. This can be done without the use of any tools.

1024

Step 2

  • Using a plastic opening tool, place the skinny flat end between the groove running along side of the device.
  • Using a twisting motion, detach the control panel from the device

Using a plastic opening tool, place the skinny flat end between the groove running along side of the device.

Using a twisting motion, detach the control panel from the device

Step 3

  • Find the groove around the outside of the green section. Use an ESD safe spudger to slowly lift the plastic panel up.

Find the groove around the outside of the green section. Use an ESD safe spudger to slowly lift the plastic panel up.

Step 4

  • After removing the green section, find the groove around the display. Insert a ESD safe spudger and carefully lift the display.

After removing the green section, find the groove around the display. Insert a ESD safe spudger and carefully lift the display.

Step 5

  • The display can lift up the display but be sure not to damage any of the cables connecting it to the mother board.
  • Remove the screw located under the display using the 00 Phillips head screwdriver.

The display can lift up the display but be sure not to damage any of the cables connecting it to the mother board.

Remove the screw located under the display using the 00 Phillips head screwdriver.

Step 6

  • Pull up on the motherboard and display. It is glued to the base so it will require a little force. Be careful though, as the board is fragile.

Pull up on the motherboard and display. It is glued to the base so it will require a little force. Be careful though, as the board is fragile.

Step 7

              Logic Board
  • Unplug the logic board from the battery. Replace the logic board with your new logic board and reassemble your device.

Unplug the logic board from the battery. Replace the logic board with your new logic board and reassemble your device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Joel Ng

Member since: 10/19/2016

239 Reputation

                                      1 Guide authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       IUPUI, Team 2-5, Baechle Fall 2016                        

                                                  Member of IUPUI, Team 2-5, Baechle Fall 2016 



                    IUPUI-BAECHLE-F16S2G5                     


                                            4 Members                     


                                            7 Guides authored