Difficulty
Easy
Steps
5
Time Required
5 minutes
Sections
1
- Volume/Power Control Button
- 5 steps
Flags
0
BackCraig Electronics CMP773
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Volume/Power Control Button
- Remove the two 3.2 mm PH000 screws near the charging port.
Remove the two 3.2 mm PH000 screws near the charging port.
1024
Step 2
- Pry the back cover from the device along bottom edge.
Pry the back cover from the device along bottom edge.
Step 3
- Continue prying along each edge of the device until back cover is free.
Continue prying along each edge of the device until back cover is free.
Step 4
- On the back cover, find the location where the volume/power button is held.
- The volume/power button is not held securely after back is removed so it may fall out of place while removing the back cover from the device.
On the back cover, find the location where the volume/power button is held.
The volume/power button is not held securely after back is removed so it may fall out of place while removing the back cover from the device.
Step 5
- Remove the old button and replace it with the new one.
Remove the old button and replace it with the new one.
Once the above steps have been successfully competed, power on the device. Enjoy your newly replaced volume/power control button.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Jessie L Morris
Member since: 03/26/2018
171 Reputation
1 Guide authored
Badges:
4
+1 more badge
Team
IUPUI, Team S1-G5, Harley Spring 2018
Member of IUPUI, Team S1-G5, Harley Spring 2018
IUPUI-HARLEY-S18S1G5
6 Members
4 Guides authored
