Difficulty

Moderate

Steps

6

Time Required

                          10 - 15 minutes

Sections

1

  • Front and Rear Camera
  • 6 steps

Flags

2

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Missing Details

Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.

  • BackCraig Electronics CMP773

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Front and Rear Camera
  • Remove the two Phillips #00 screws from the bottom of the screen.

Remove the two Phillips #00 screws from the bottom of the screen.

1024

Step 2

  • Insert a plastic opening tool underneath the screen.
  • Once the first tool is inserted, insert another opening tool along the same side of the tablet.
  • Pry them in opposite directions until the casing pops.

Insert a plastic opening tool underneath the screen.

Once the first tool is inserted, insert another opening tool along the same side of the tablet.

Pry them in opposite directions until the casing pops.

Step 3

  • Move the opening tool along the edge of the tablet to continue popping the casing loose.
  • Once the casing is about half loose, remove it by hand.

Move the opening tool along the edge of the tablet to continue popping the casing loose.

Once the casing is about half loose, remove it by hand.

Step 4

  • Remove the tape from the power connection for the camera unit.
  • Unhinge the clamp on the camera power connection to expose the removable plug.

Remove the tape from the power connection for the camera unit.

Unhinge the clamp on the camera power connection to expose the removable plug.

Step 5

  • Gently remove the power ribbon from the connector.

Gently remove the power ribbon from the connector.

Step 6

  • Use the spudger to dislodge camera unit from the casing and remove it from the device.

Use the spudger to dislodge camera unit from the casing and remove it from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Luke VanLangevelde

Member since: 11/07/2019

133 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       IUPUI, Team S3-G4, Harley Fall 2019                        

                                                  Member of IUPUI, Team S3-G4, Harley Fall 2019 



                    IUPUI-HARLEY-F19S3G4                     


                                            4 Members                     


                                            2 Guides authored