Difficulty
Moderate
Steps
7
Time Required
10 - 15 minutes
Sections
1
- Battery
- 7 steps
Flags
0
BackCraig Electronics CMP773
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Remove the two 3.2 mm PH000 screws near the charging port.
Remove the two 3.2 mm PH000 screws near the charging port.
1024
Step 2
- Pry the back cover from the device along the bottom edge.
Pry the back cover from the device along the bottom edge.
Step 3
- Continue prying along the edge of the device until the back cover is free.
Continue prying along the edge of the device until the back cover is free.
Step 4
- Pry the battery free from the device using a plastic opening tool.
Pry the battery free from the device using a plastic opening tool.
Step 5
- Desolder the faulty battery wires.
Desolder the faulty battery wires.
Step 6
- Solder the replacement battery wires to the circuit board.
Solder the replacement battery wires to the circuit board.
Step 7
- Apply adhesive between the replacement battery and the device before installation.
Apply adhesive between the replacement battery and the device before installation.
Once the above steps have been successfully competed, power on the device. Enjoy your newly replaced battery.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Jacob Hampton
Member since: 03/26/2018
145 Reputation
1 Guide authored
Badges:
3
Team
IUPUI, Team S1-G5, Harley Spring 2018
Member of IUPUI, Team S1-G5, Harley Spring 2018
IUPUI-HARLEY-S18S1G5
6 Members
4 Guides authored
