Difficulty

Moderate

Steps

14

Time Required

                          25 minutes

Sections

4

  • Back Cover
  • 3 steps
  • Volume Controls
  • 3 steps
  • Battery
  • 2 steps
  • LCD Screen
  • 6 steps

Flags

0

  • BackCraig CMP801

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Cover
  • Locate the opening line between the cover and the device. Then locate the groove near the charging port.

Locate the opening line between the cover and the device. Then locate the groove near the charging port.

1024

Step 2

  • Use a metal spudger to separate the back cover from the front touch screen.
  • To do this, place the metal spudger in between the groove near the charging port of the device to unlatch the first clip.

Use a metal spudger to separate the back cover from the front touch screen.

To do this, place the metal spudger in between the groove near the charging port of the device to unlatch the first clip.

Step 3

  • Continue to separate all of the clips around the device until the back cover comes off completely.

Continue to separate all of the clips around the device until the back cover comes off completely.

Step 4

              Volume Controls
  • After taking out the back cover, locate the black flap.
  • Open the black flap with the plastic opening tools.
  • Be careful not to break the flap when you open it.

After taking out the back cover, locate the black flap.

Open the black flap with the plastic opening tools.

Be careful not to break the flap when you open it.

Step 5

  • Once the tab is released, use the angled tweezers to take out the tab.
  • Be careful not to scratch the tab.

Once the tab is released, use the angled tweezers to take out the tab.

Be careful not to scratch the tab.

Step 6

  • Use the angled tweezers to pull the volume controls out and replace it with a new one.

Use the angled tweezers to pull the volume controls out and replace it with a new one.

Step 7

              Battery
  • Locate the white plug next to the battery.
  • Use your fingers to pull off white plug that connected to the battery.
  • Be careful not to pull or break the wires on the bottom.

Locate the white plug next to the battery.

Use your fingers to pull off white plug that connected to the battery.

Be careful not to pull or break the wires on the bottom.

Step 8

  • The battery should only be connected to the LCD by adhesive tape.
  • Using force, carefully remove the battery while holding the LCD in place.

The battery should only be connected to the LCD by adhesive tape.

Using force, carefully remove the battery while holding the LCD in place.

Step 9

              LCD Screen
  • Open the three black flaps located on each side of the motherboard.

Open the three black flaps located on each side of the motherboard.

Step 10

  • Then detach each of the three tabs from the LCD screen.

Then detach each of the three tabs from the LCD screen.

Step 11

  • Using a Philips 0 Screwdriver, remove the screws connecting the speaker to the motherboard.
  • Remove black plastic speaker holder.

Using a Philips 0 Screwdriver, remove the screws connecting the speaker to the motherboard.

Remove black plastic speaker holder.

Step 12

  • Remove the gray tape connecting the motherboard to the metal slate.
  • Use a spudger to separate the metal slate from the front touch screen.

Remove the gray tape connecting the motherboard to the metal slate.

Use a spudger to separate the metal slate from the front touch screen.

Step 13

  • Carefully slide out the metal slate and LCD screen from underneath the motherboard.

Carefully slide out the metal slate and LCD screen from underneath the motherboard.

Step 14

  • Flip over the metal slate and separate the LCD screen from it.

Flip over the metal slate and separate the LCD screen from it.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 1 other contributor 


                    Anh

Member since: 09/25/2017

289 Reputation

                                      1 Guide authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       University of North Texas, Team S2-G2, Thompson Fall 2017                        

                                                  Member of University of North Texas, Team S2-G2, Thompson Fall 2017 



                    UNT-THOMPSON-F17S2G2                     


                                            4 Members                     


                                            5 Guides authored