Craftsman Model 315 10721 Table Guard Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          25 - 30 minutes

Sections

Table Guard
4 steps

Flags

BackCraftsman Model 315.10721
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Table Guard

Using a flathead screwdriver, remove the 1/2" flathead screw to allow the table guard to pivot.

Using a flathead screwdriver, remove the 1/2" flathead screw to allow the table guard to pivot.

1024

Step 2

Pivot the table guard from its upright position to an angle.
Using a Phillips #1 screwdriver, remove the 1" Phillips screw and the nut on the opposite side.

Pivot the table guard from its upright position to an angle.

Using a Phillips #1 screwdriver, remove the 1" Phillips screw and the nut on the opposite side.

Step 3

Using the Phillips #1 screwdriver, remove eight 1" Philips screws from the main case.
Carefully remove the main case to expose the inside of the saw.

Using the Phillips #1 screwdriver, remove eight 1" Philips screws from the main case.

Carefully remove the main case to expose the inside of the saw.

Step 4

Remove the old table guard by gently lifting it away from the main case.
Replace the old table guard with the new one by placing it in the same orientation as the one removed.

Remove the old table guard by gently lifting it away from the main case.

Replace the old table guard with the new one by placing it in the same orientation as the one removed.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors

                    Riley Hilliker

Member since: 10/14/2014

557 Reputation

                                      5 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       Cal Poly, Team 4-47, Amido Fall 2014                        

                                                  Member of Cal Poly, Team 4-47, Amido Fall 2014 



                    CPSU-AMIDO-F14S4G47                     


                                            4 Members                     


                                            5 Guides authored

Roger Coyle - Jan 7, 2021

Where can I get a replacement table guard???

Where can I get a replacement table guard for this jig saw????????

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team