Difficulty

Easy

Steps

3

Time Required

                          10 minutes            

Sections

1

  • Cord
  • 3 steps

Flags

0

  • BackCraftsman Model 315.10721

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Cord               
  • Remove the two 1" Phillips screws using a #1 Phillips screwdriver.
  • Remove the three 1/2" Phillips screws using a #1 Phillips screwdriver.
  • Once the five screws are removed, lift the handle cover from the saw.
  • Each screw has a corresponding nut on the opposite side of the power saw

Remove the two 1" Phillips screws using a #1 Phillips screwdriver.

Remove the three 1/2" Phillips screws using a #1 Phillips screwdriver.

Once the five screws are removed, lift the handle cover from the saw.

Each screw has a corresponding nut on the opposite side of the power saw

1024

Step 2

  • Remove the 1/2" Phillips screw that is securing the switch using a Phillips #1 screwdriver.

Remove the 1/2" Phillips screw that is securing the switch using a Phillips #1 screwdriver.

Step 3

  • Using a Phillips #00 screwdriver or a small diameter screwdriver, gently insert it into the leads. When the screwdriver is inserted into the lead, it will release the wire.
  • The leads are where the black and white wires from the power cord are plugged in.
  • Release both the black and white wires and gently pull them from the leads.
  • To install the new cord, insert the wires of the new cord in the same way that they were removed.

Using a Phillips #00 screwdriver or a small diameter screwdriver, gently insert it into the leads. When the screwdriver is inserted into the lead, it will release the wire.

The leads are where the black and white wires from the power cord are plugged in.

Release both the black and white wires and gently pull them from the leads.

To install the new cord, insert the wires of the new cord in the same way that they were removed.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 

                    Riley Hilliker                     

Member since: 10/14/2014

557 Reputation

                                      5 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges                           

Team

                       Cal Poly, Team 4-47, Amido Fall 2014                        

                                                  Member of Cal Poly, Team 4-47, Amido Fall 2014 



                    CPSU-AMIDO-F14S4G47                     


                                            4 Members                     


                                            5 Guides authored