Difficulty
Easy
Steps
3
Time Required
15 - 20 minutes
Sections
1
- Brush
- 3 steps
Flags
0
BackCraftsman Model 315.10721
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Brush
- Using a flathead screwdriver, remove the brush caps on the outer casing of the saw near the motor.
Using a flathead screwdriver, remove the brush caps on the outer casing of the saw near the motor.
1024
Step 2
- Using a Phillips #00 screwdriver or a small diameter nail, carefully pull out the washer.
- The washer is seurely held in place and may require force to remove
Using a Phillips #00 screwdriver or a small diameter nail, carefully pull out the washer.
The washer is seurely held in place and may require force to remove
Step 3
- After the washers are removed, gently grab the old brushes and remove them from the motor.
- When reassembling make sure the curvature of the brushes match curvature of the motor.
After the washers are removed, gently grab the old brushes and remove them from the motor.
When reassembling make sure the curvature of the brushes match curvature of the motor.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Riley Hilliker
Member since: 10/14/2014
557 Reputation
5 Guides authored
Badges:
11
+8 more badges
Team
Cal Poly, Team 4-47, Amido Fall 2014
Member of Cal Poly, Team 4-47, Amido Fall 2014
CPSU-AMIDO-F14S4G47
4 Members
5 Guides authored
