Difficulty

Moderate

Steps

6

Time Required

                          20 minutes

Sections

3

  • Battery
  • 1 step
  • Bottom Casing
  • 3 steps
  • SSD
  • 2 steps

Flags

2

Bullets!

Better coordination with markups and the color/type of bullets will help make this guide more clear!

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackGoogle Cr-48 Chromebook

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

  • make sure nothing is attached (such as AC adapter, USB, VGA, audio jack).remove any inserted SD card.

What you need

Step 1

              Battery
  • Slide the switch on the bottom of the laptop until the battery pops out.
  • Once the battery pops out, you can remove it.

Slide the switch on the bottom of the laptop until the battery pops out.

Once the battery pops out, you can remove it.

1024

Step 2

              Remove Rear Rubber Feet
  • Using a pair of tweezers, remove the two rear rubber feet to expose two hidden screws.

Using a pair of tweezers, remove the two rear rubber feet to expose two hidden screws.

Step 3

              Remove Screws
  • Remove ten 3 mm screws in the battery compartment using a Phillips #00 screwdriver.
  • Remove two 4.5 mm screws under the rubber feet using a Phillips #00 screwdriver.

Remove ten 3 mm screws in the battery compartment using a Phillips #00 screwdriver.

Remove two 4.5 mm screws under the rubber feet using a Phillips #00 screwdriver.

Step 4

  • Starting where the body of the laptop and the laptop screen meet, pry apart the lower case from the rest of the laptop.
  • The case is easier to remove when separating in a clockwise motion, as seen in the pictures.

Starting where the body of the laptop and the laptop screen meet, pry apart the lower case from the rest of the laptop.

The case is easier to remove when separating in a clockwise motion, as seen in the pictures.

Step 5

              Locate SSD and Remove Screw
  • Find the SSD located on a corner of the side directly opposite where the laptop screen and device body are connected.
  • Remove one black screw on the SSD using a PH #00 screwdriver.
  • Size ph#00, approximately 3 mm long.
  • Once unscrewed, the SSD will pop up from the device.

Find the SSD located on a corner of the side directly opposite where the laptop screen and device body are connected.

Remove one black screw on the SSD using a PH #00 screwdriver.

Size ph#00, approximately 3 mm long.

Once unscrewed, the SSD will pop up from the device.

Step 6

              Remove SSD
  • Firmly grasp the SSD with two fingers slightly upwards and pull.

Firmly grasp the SSD with two fingers slightly upwards and pull.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      5 other people completed this guide.

Author

                                      with 3 other contributors 


                    Athar

Member since: 09/09/2014

365 Reputation

                                      2 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       CSU Fullerton, Team 2-2, Bruce Fall 2014                        

                                                  Member of CSU Fullerton, Team 2-2, Bruce Fall 2014 



                    CSUF-BRUCE-F14S2G2                     


                                            3 Members                     


                                            10 Guides authored