Difficulty
Moderate
Steps
2
Time Required
Suggest a time??
Sections
1
- Battery
- 2 steps
Flags
0
BackNikon Coolpix S01
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Before starting, make sure the camera is powered off.
- Take the Hex and PH000 bit to remove a 2mm screw from the left side of the camera.
- Next, remove the 2mm screw from the right side.
- Lastly, remove the 3mm screw from the bottom of the camera.
Before starting, make sure the camera is powered off.
Take the Hex and PH000 bit to remove a 2mm screw from the left side of the camera.
Next, remove the 2mm screw from the right side.
Lastly, remove the 3mm screw from the bottom of the camera.
1024
Step 2
- Once the two 2mm screws and the 3 mm screw have been removed, use the smallest plastic opening tool and pull up on the sides to reveal the inside of the camera.
- Next, use the same small plastic opening tool and gently pull out the battery.
- To reassemble, follow the steps in reverse order.
Once the two 2mm screws and the 3 mm screw have been removed, use the smallest plastic opening tool and pull up on the sides to reveal the inside of the camera.
Next, use the same small plastic opening tool and gently pull out the battery.
To reassemble, follow the steps in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Author
with 1 other contributor
Becca Hall
Member since: 10/13/2015
173 Reputation
1 Guide authored
Badges:
7
+4 more badges
Team
Sam Houston State, Team 2-3, Blackburne Fall 2015
Member of Sam Houston State, Team 2-3, Blackburne Fall 2015
SHSU-BLACKBURNE-F15S2G3
4 Members
9 Guides authored