Difficulty

Moderate

Steps

6

Time Required

                          5 - 10 minutes

Sections

3

  • Back Cover
  • 2 steps
  • Battery
  • 1 step
  • Daughterboard
  • 3 steps

Flags

0

  • BackCoolpad Defiant

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Cover
  • Turn the phone with the back cover facing towards you.
  • Carefully remove the back cover by holding one corner of the case and carefully pulling it away from the phone.
  • The plastic case and inner components can break if not pulled carefully, so pull cautiously.

Turn the phone with the back cover facing towards you.

Carefully remove the back cover by holding one corner of the case and carefully pulling it away from the phone.

The plastic case and inner components can break if not pulled carefully, so pull cautiously.

1024

Step 2

  • Remove the back cover from your device.

Remove the back cover from your device.

Step 3

              Battery
  • Find the gap on the bottom of the battery.
  • With a tool or with your hands, pull the battery upward and set it aside safely.
  • Remember to return the battery once you are done, safely placing it in the correct position or as how you first saw it.
  • Be careful with old or damaged batteries and dispose of it appropriately

Find the gap on the bottom of the battery.

With a tool or with your hands, pull the battery upward and set it aside safely.

Remember to return the battery once you are done, safely placing it in the correct position or as how you first saw it.

Be careful with old or damaged batteries and dispose of it appropriately

Step 4

              Daughterboard
  • Remove all fifteen screws using the Phillips #000 screwdriver.
  • Remove the back panel after all screws are removed.

Remove all fifteen screws using the Phillips #000 screwdriver.

Remove the back panel after all screws are removed.

Step 5

  • Disconnect the metal cable using the plastic spudger.
  • The remove the glued down speaker from the backing.
  • Disconnect the little black wire from lower logic board.

Disconnect the metal cable using the plastic spudger.

The remove the glued down speaker from the backing.

Disconnect the little black wire from lower logic board.

Step 6

  • Using the plastic spudger remove the lower logic board because the only thing that is holding it down is glue.

Using the plastic spudger remove the lower logic board because the only thing that is holding it down is glue.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Elijah Gastin

Member since: 09/21/2018

100 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       University of North Texas, Team S5-G6, Thompson Fall 2018                        

                                                  Member of University of North Texas, Team S5-G6, Thompson Fall 2018 



                    UNT-THOMPSON-F18S5G6                     


                                            3 Members                     


                                            10 Guides authored