Difficulty

Moderate

Steps

5

Time Required

                          15 minutes

Sections

2

  • Coolpad 3300A Disassembly
  • 4 steps
  • Camera
  • 1 step

Flags

1

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • BackCoolpad 3300A

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Coolpad 3300A Disassembly
  • After removing the back of the phone (not pictured), remove the battery by lifting up from the bottom with your thumb. There will be a groove that allows you to remove the battery with your thumb.

After removing the back of the phone (not pictured), remove the battery by lifting up from the bottom with your thumb. There will be a groove that allows you to remove the battery with your thumb.

1024

Step 2

  • Remove the four screws (30 mm long) which hold the front and back half of the unit together using a Phillips #000 screwdriver. There will be one screw in each corner.

Remove the four screws (30 mm long) which hold the front and back half of the unit together using a Phillips #000 screwdriver. There will be one screw in each corner.

Step 3

  • Use a metal spudger to release all of the clips around the phone. These clips are used to hold the front and back panel on the phone together.

Use a metal spudger to release all of the clips around the phone. These clips are used to hold the front and back panel on the phone together.

Step 4

  • After the clips are released, carefully separate the back housing from the phone. Notice the sticker that appears in the red box holds the phone together, but can be peeled apart.

After the clips are released, carefully separate the back housing from the phone. Notice the sticker that appears in the red box holds the phone together, but can be peeled apart.

Step 5

              Camera
  • Carefully use the nylon spudger to pry the camera from its connector.

Carefully use the nylon spudger to pry the camera from its connector.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 3 other contributors 


                    Cordell Miller

Member since: 03/26/2018

306 Reputation

                                      2 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       IUPUI, Team S1-G3, Harley Spring 2018                        

                                                  Member of IUPUI, Team S1-G3, Harley Spring 2018 



                    IUPUI-HARLEY-S18S1G3                     


                                            6 Members                     


                                            8 Guides authored