Difficulty

Very easy

Steps

9

Time Required

                          10 minutes

Sections

1

  • Conduit Attachment
  • 9 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackConduit

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Step 1

              Parts Overview
  • The parts depicted are the attachment pieces you should have (in addition to the conduit)

The parts depicted are the attachment pieces you should have (in addition to the conduit)

1024

Step 2

              Cover Piece
  • Pull the cover over the conduit and the wires

Pull the cover over the conduit and the wires

Step 3

              Outer Yellow Seal
  • Pull the outer yellow seal over the wires and the conduit
  • The end with the ridge should be pulled down first (i.e. that end will be closer to the cover)

Pull the outer yellow seal over the wires and the conduit

The end with the ridge should be pulled down first (i.e. that end will be closer to the cover)

Step 4

              The Screw Piece
  • Pull this piece over the wires and then screw it into the conduit

Pull this piece over the wires and then screw it into the conduit

Step 5

              Connector Piece
  • Put the connector piece into the node (may have to hold it in place for the subsequent steps)

Put the connector piece into the node (may have to hold it in place for the subsequent steps)

Step 6

              Inner Yellow Seal
  • Pull the yellow seal over the inside of the connector piece

Pull the yellow seal over the inside of the connector piece

Step 7

              Tightener Piece
  • Screw the tightener piece onto the connector

Screw the tightener piece onto the connector

Step 8

              Putting it All Together
  • Pull the wires through the connector piece and then screw the conduit onto the connector

Pull the wires through the connector piece and then screw the conduit onto the connector

Step 9

              Final Overview
  • This is how it should look after everything is connected

This is how it should look after everything is connected

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Nicholas Jeng

Member since: 01/16/2018

529 Reputation

                                      3 Guides authored                  



                       Badges:
                       2