Conair Infiniti Pro Spin Air Brush Circuit Board Replacement Repair Guide

Difficulty

Difficult

Steps

11

Time Required

                          6 minutes            

Sections

1

• Circuit Board
• 11 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

• BackConair Infiniti PRO Spin Air Brush

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Circuit Board               

• Look for the black screw covers near the top of the brush. Take the covers off with flat head screw driver.

Look for the black screw covers near the top of the brush. Take the covers off with flat head screw driver.

1024

Step 2

• Use a Phillips #1 screwdriver to remove the screws that secure the brush head.

Use a Phillips #1 screwdriver to remove the screws that secure the brush head.

Step 3

• Gently take off the brush top.

Gently take off the brush top.

Step 4

• Take out the black gear by pulling up.

Take out the black gear by pulling up.

Step 5

• Take the top of air filter off.

Take the top of air filter off.

Step 6

• Use flat head screwdriver to pop off the bottom air filter.

Use flat head screwdriver to pop off the bottom air filter.

Step 7

• Gently use a flat head screw driver to take of the black cover, covering the plastic shell.

Gently use a flat head screw driver to take of the black cover, covering the plastic shell.

Step 8

• Using your flat head screwdriver to go along the seams of the plastic shell till the shell pops apart.

Using your flat head screwdriver to go along the seams of the plastic shell till the shell pops apart.

Step 9

• Then take the switch cover and buttons off.

Then take the switch cover and buttons off.

Step 10

• Then take your Philips screw driver (ph1 size head) and unscrew the circuit board. The screw is located in the middle of the board.

Then take your Philips screw driver (ph1 size head) and unscrew the circuit board. The screw is located in the middle of the board.

Step 11

• Remove the black heater cover by sliding it off.
• Desolder each of the four connections, and remove the circuit board.

Remove the black heater cover by sliding it off.

Desolder each of the four connections, and remove the circuit board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    andrew shirley                     

Member since: 08/23/2017

289 Reputation

                                      2 Guides authored                  



                       Badges:
                       3

Team

                       IUPUI, Team S1-G3, Freund Fall 2017                        

                                                  Member of IUPUI, Team S1-G3, Freund Fall 2017 



                    IUPUI-FREUND-F17S1G3                     


                                            3 Members                     


                                            2 Guides authored