Computer King Muffin Kinder 7 Screen Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 - 30 minutes

Sections

Screen
8 steps

Flags

Slice and Dice

The steps in this guide should be split up and made into a series of prerequisite guides.

BackComputer King Muffin Kinder 7
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

Make sure to power off the device before you begin to take apart your device. Not doing so could potentially cause harm.

What you need

Step 1

              Screen

Use the plastic opening tool help push out the microSD card from the microSD slot.

Use the plastic opening tool help push out the microSD card from the microSD slot.

1024

Step 2

Use the plastic opening tool to unclip the plastic front from the plastic back. Use the MicroSD slot to initially start the unclipping.

Use the plastic opening tool to unclip the plastic front from the plastic back. Use the MicroSD slot to initially start the unclipping.

Step 3

Unscrew the nine 3.0 mm Phillips #00 screws.

Unscrew the nine 3.0 mm Phillips #00 screws.

Step 4

The battery is glued onto the black plastic. Use the plastic opening tool to pry the battery from the black plastic

The battery is glued onto the black plastic. Use the plastic opening tool to pry the battery from the black plastic

Step 5

There will be a black strip connected to the screen.
Use the pointy end of the spudger to unstick the black strip that is glued onto the screen.

There will be a black strip connected to the screen.

Use the pointy end of the spudger to unstick the black strip that is glued onto the screen.

Step 6

You will need to remove 2 ribbon cables, one that is connected to the touch screen (by the battery) and one that is connected to the yellow plastic (by the speaker).
Use the flat end of the spudger to lift the black panel covering the ribbon cables.

You will need to remove 2 ribbon cables, one that is connected to the touch screen (by the battery) and one that is connected to the yellow plastic (by the speaker).

Use the flat end of the spudger to lift the black panel covering the ribbon cables.

Step 7

Pull the two ribbon cables out so that they are no longer connected to the logic board.

Pull the two ribbon cables out so that they are no longer connected to the logic board.

Step 8

Lift up the logic board and black plastic so that they are no longer covering the screen
Lift out the screen.

Lift up the logic board and black plastic so that they are no longer covering the screen

Lift out the screen.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 3 other contributors

                    Katherine

Member since: 01/22/2015

412 Reputation

                                      3 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       UWT Liner: Group 2                        

                                                  Member of UWT Liner: Group 2 



                    Community                     


                                            4 Members                     


                                            6 Guides authored

Slice and Dice#

Introduction#

What you need#

Team#

Slice and Dice

Introduction

What you need

Team